Woodstock W2000 manual Unpacking Piece Inventory, Contents of the bolt bag

D. Unpacking E. Piece Inventory

The Rebel® is designed for heavy-duty use, yet it weighs only 35 pounds and is completely portable. However, when lifting, we must caution against improper lifting techniques. Always keep your back straight and lift with your legs. If you are limited by the amount of weight you can lift and carry, please refrain from moving The Rebel® until you get the necessary assistance.

At this time, slide the solid foam packing out. The parts are arranged in two layers of packing. Remove the parts in an orderly fashion. This will simplify identifi- cation and make inventory and assembly that much easier. When removing the parts, please take care not to destroy the foam and cardboard carton. It is a good idea to save the carton for future storage or shipment if necessary. After you have completed your inventory, inspect all the parts (especially the contact areas) for burrs and other irregularities which might hinder the assembly process. If you find any burrs or flash left over from the machining or casting process, simply sand or file them flat. Please note that while this is not a common occurrence, it is possible that one or more of the parts could have been missed during the machining and deburring process.

Carefully remove the items packed in the carton. It may be a good idea to save the carton and packing material in case it might be needed in the future. Upon removal of all items from the package, you should have:

1	Working Table	1	Plastic Insert Assembly
4	Legs	1	Starting Pin
4	Rubber Feet	1	Safety Guard
2	Short Side Panels	1	Safety Guard Bracket
2	Long Side Panels	1	Safety Guard Rod
2	Aluminum Fences	1	Lock Knob
2	Wood Facings	1	Miter Gauge
4	Fence Lock Handles	1	Miter Gauge Handle
4	T-Nuts (Bagged)	1	Bolt Bag

1 Arm

Contents of the bolt bag.

Description:	Size:	Qty:
Cap Screws:	1/4''- 28 x 5/8''	20
	1/4''- 28 x 1''	2
Setscrews:	10- 32 x 3/4''	4
Hex Nuts:	10 - 32	4
	1/4''- 20	4
Flat Washers:	1/4''	4
	5/16''	1
Flat Head Screws:	1/4''- 20 x 11/4''	4
Hex Bolt:	5/16''- 18 x 3/4''	1
Wrench:	3/16''	1
	5/64''	1

In the event that any non-propriety parts are missing (e.g. a bolt or nut etc..) we would be glad to replace it. For expediency, replacements can be obtained from your local hardware store.

Figure 1. Rebel® parts ready for assembly.

W2000 Rebel® – 5