Wow Wee 8032 Miscellaneous directional pad functions, Stop function, Hold function, Function

Models: 8032

1 24
Download 24 pages 55.77 Kb
Page 13
Image 13
Miscellaneous directional pad functions

MISCELLANEOUS DIRECTIONAL PAD FUNCTIONS / STOP FUNCTION / HOLD FUNCTION

Miscellaneous directional pad functions

This section describes miscellaneous functions of the directional pad on the Roboboa remote controller.

Stop function

Press the red dot on the directional pad all the way inwards to activate the Stop function.

The following table lists more Stop functions:

Hold function

The Hold function turns your robot into a smart night light. The light sensor is located on the back of the robot’s neck.

Light sensor

The following table outlines the Hold function:

Function

Description

Indicators

First Stop

Press the Stop button once to halt the

 

 

robot in his tracks. He will not move

 

 

or see but you’ll be able to move him

 

 

from the remote. If he receives no more

 

 

signals from the remote controller, he

 

 

resets to Aware mode after about 2

 

 

minutes.

 

Second Stop

Press the Stop button to Reset him to

 

 

his default position and enter Aware

 

 

mode.

 

 

While he is resetting to his default

 

 

position, his eyes glow orange. During a

 

 

reset, he will unfold from any position

 

 

he was in previously to the default

 

 

position (see page 7).

 

 

When you press the stop command,

 

 

Roboboa will exit from any action

 

 

except Program. (In Program, the Stop

 

 

command acts as a half-second delay

 

 

in the program sequence see page 17.)

 

Function

Description

Indicators

Hold

Press and hold the directional pad

 

 

inwards completely for more than 2

 

 

seconds to activate the Hold function.

 

 

Doing this turns Roboboa into a dark-

 

 

ness-activated desk lamp, turning up

 

 

his lights in the dark and lowering them

 

 

in the light.

 

If the room is bright, his face flashes as above, but when the room goes dark his entire face lights up, as shown, for about 6 hours.

When in Hold mode, your robot stops moving and turns off all his face lights to save power. You can tell your robot is in Hold mode because his smile flashes every few seconds .

IMPORTANT: When Roboboa is in Hold mode, he will not power down on his own. Roboboa can last for many days in Hold mode on fresh batteries, but make sure to turn him off when not in use.

11

Page 13
Image 13
Wow Wee 8032 user manual Miscellaneous directional pad functions, Stop function, Hold function, Function, Description