Wow Wee 8032 user manual Sleep Mode / Guard Modes, Sleep mode, Guard modes

SLEEP MODE / GUARD MODES

Even if you interact with your Roboboa once the alarm is set, he’ll interrupt whatever he’s doing to play the alarm. If you need your robot to remind you to go somewhere in two hours (for example), you can still use him as a light or for fun and he’ll remember to activate his alarm.

Note: To clear your alarm, wake up your Roboboa by pressing Stop, then press Reset (hold the Tail / Head button for more than 2 seconds), or execute a Shutdown command (hold the Mode button then press Stop within 2 seconds), or power your robot Off from the power button in his tail.

When his alarm goes off, you can turn him off or Stop by pressing any Mode button.

Sleep mode

Put Roboboa to sleep so you can carry him around and all his programs and alarm settings will be remembered.

Function	Button combination	Description
Sleep	Press and hold the	Roboboa yawns and then folds
	Explore button for	himself into his sleep position.
	more than 2 seconds

CAUTION: If you have set an alarm, he will wake up on his own, so do not position him where he will hit things upon waking.

NOTE: If left asleep for more than 24 hours, he will enter Shutdown mode and all programs and settings will be lost unless you have pressed Daily. (See page 15)

Guard modes

Roboboa can be used as a vigilant guard that can “protect” your desk, shelf, or doorway. Guard mode scans a room from left to right at about 45 degrees on each side, and to a range of several feet.

NOTE: Before activating any guard mode, be sure to place him on an open surface or floor.

To activate the Guard mode, press the Guard button. When your Roboboa enters guard mode, he first “loads” himself up, then starts to scan the room for objects.

The following table outlines the Guard mode functions from the remote controller:

Function	Button combination	Description
Guard	Press the Guard button	NOTE: This function times out after
		about 2 hours, then re-enters Aware
		mode.
Sentry	Press and hold the	A spin-in-place-shooting mode,
	Guard button for more	your robot scans the nearby area for
	than 2 seconds	intruders and objects. Anything that
		falls within several feet of his face
		gets ray-beamed.
		After 12 shots, he reloads himself
		and will start to spin the other way
		NOTE: Sentry mode times out after
		about 20 minutes, then re-enters
		Aware mode.
Patrol	Hold the Mode	A roving patrol robot that cannon-
	button then press the	rounds anything that comes within
	Guard button within 2	several feet as he moves around.
	seconds	After 4 shots, he’ll turn around and
		rove in another direction.
		NOTE: Patrol stops after about 10
		minutes, then re-enters Aware mode.

16