Installation
Keychain Remote
BATTERY
ARM
PANIC
DISARM
LIGHTS
ON
LIGHTS
OFF
Registering the Keychain Remote with the Security Console
•Fit two AAA Alkaline batteries in the battery compartment in the back of the Keychain Remote.
•Press and hold the ARM button for about a second. The LED indicator flashes twice when you release it. This confirms the Keychain Remote has generated a new random security code.
•Set the slide switch on the Security Console to INSTALL.
•Press ARM. The console beeps once to confirm that the Keychain Remote has been registered.
•Return the console slide switch to the RUN1 or RUN2 position.
Testing the Keychain Remote
•Set the slide switch on the Security Console to RUN1 or RUN2.
•Press ARM on the Keychain Remote. The console beeps once to confirm and the ARM indicator lights. Press DISARM.
Note: The Keychain Remote always arms the system instantly - there is no exit or entry delay.
•Press LIGHTS ON and LIGHTS OFF to turn on and off a light connected to a Lamp Module with the same House Code and Unit Code as set on the Security Console.
•Press ARM and DISARM together to trip the panic alarm. Press DISARM to stop the alarm.
8
Installation
Door/Window Sensor
DOOR/WINDOW SENSOR
DELAY
MAX MIN
DOOR/WINDOW SENSOR
Ideal location
TEST
Two windows (requires accessory magnetic switch pair)
DOOR/WINDOW SENSOR
Sliding window
Installing the Door/Window Sensor
•Attach the Door/Window Sensor to the wall using the mounting screws provided.
•Fit the Door/Window Sensor as high as possible at the top of the door/window.
•Make sure the arrows on the magnetic switch halves are facing each other and that they separate cleanly when the door or window is opened.
•Set the DELAY slide switch to MIN to always trigger the alarm instantly (for windows), or to MAX to trigger the alarm after a preset entry delay when the system is armed in DELAY mode (for doors).
Registering the Door/Window Sensor with the Security Console
•Fit two AA Alkaline batteries in the battery compartment.
•Press and hold the TEST button for about a second. The LED flashes twice when you release it. This confirms it has generated a new random security code.
•Set the slide switch on the Security Console to INSTALL.
•Press the TEST button on the Door/Window Sensor. The console beeps once to confirm and the next available zone LED lights.
•Return the console slide switch to the RUN1 or RUN2 position.
Testing the Door/Window Sensor
•Set the slide switch on the Security Console to RUN2.
•Open the door or window with the sensor attached. The console beeps to acknowledge and the zone LED lights.
9
