Xantech D5KP installation instructions Connections, Zone OUT D5RH

3. Connections

ZONE OUT – D5RH

The ‘ZONE OUT’ RJ-45 connector’s interface with D5KP Amplified Keypad through CAT-5 cables wired to the T-568A Standard. These connectors carry IR information from the keypad as well as audio information to the D5KP Amplifier Keypad. Status information is also carried between the D5RH chassis and the Amplifier Keypads. While a great deal of information is handled by the ‘ZONE OUT’ connections, the connections are straightforward. Simply connect CAT-5 cables terminated to the T- 568A configuration (Figure 2.0) from each Amplifier Keypad to the corresponding ‘ZONE OUT’ connector as shown in Figure 3.0.

Note: For wire runs up to 150', the CAT-5 connections are all that is necessary. For wire runs over 150', use the AUX POWER OUT connectors as described in the section entitled Auxiliary Power Connector (AUX POWER OUT).

D5KP Rear D5KP Rear

D5RH

	-	Cat-5
L+ L- R+ R-		+
SPEAKERS	PWR IN

Cat-5	L+	L- R+ R-	- +
		SPEAKERS	PWR IN

Cat-5

Cat-5

L+ L- R+ R-	- +	L+ L- R+ R-	- +
SPEAKERS	PWR IN	SPEAKERS	PWR IN
D5KP Rear		D5KP Rear

Figure 3.0: ZONE OUT Connections

- 11 -