Xantech D5KP Internal IR Enable IR INT, External IR Enable IR EXT, Local Source LOCK-OUT Locl DET

SETUP PARAMETERS (continued)

INTERNAL IR ENABLE (IR INT)

This setting allows the built-on IR Receiver to be disabled if desired. This feature is useful in the built- in IR receiver is being flooded by a plasma TV, compact fluorescent light or sunlight. The Local IR Receiver input on the rear of the unit remains active regardless of this setting. The built-in IR Receiver is enabled by default.

The settings for this control can be adjusted from ON to OFF only.

EXTERNAL IR ENABLE (IR EXT)

This setting allows the external IR Receiver connection to be disabled if desired. The internal IR Receiver input on the front of the unit remains active regardless of this setting. The external IR Receiver is disabled by default.

The settings for this control can be adjusted from ON to OFF only.

LOCAL SOURCE LOCK-OUT (LOCL DET)

This setting determines if the LOCAL SOURCE can be selected. By default, the LOCAL SOURCE can be selected.

The settings for this control can be adjusted from ON to OFF only.

SOURCE LOCK-OUT (SRC LCK)

This setting determines which sources can be selected in the zone in which the D5KP is installed, allowing for parental control or removing the source selection option if that particular source will not be connected. By default, all connected sources can be selected.

Source lock-out can be set by both the end-user and the installer under the “USR” setting. The installer can keep the end-user from using this feature by using the “ON” setting.

USER PARAMETER LOCK-OUT (USR)

User parameters can also be restricted under Installer Setup. The User parameters that can be restricted are BASS, TREBLE, BALANCE, DRC, LOUDNESS, WHM, and DND. This setting determines which sources can be selected in the zone in which the D5KP is installed, allowing for parental control. By default, all connected sources can be selected by the USR. In “SETUP PARAMETERS”, this is noted by “USR” next BASS, TREBLE, BALANCE, DRC, LOUDNESS, WHM, and DND. If USR is not selected, than these parameters cannot be changed in USER PARAMETERS

- 21 -