Xantech D5KP D5IP Source Input Wall Plate, External IR Receiver Connections

D5IP Source Input Wall Plate

Interconnecting between the D5KP and the D5IP Source Input Plate consists of plugging in a CAT-5 cable terminated to an RJ-45 connector wired to T-568A standard (see Figure 2.0) to the RJ-45 jack on the rear of the D5IP. The other end simply plugs into the LOCAL PORT RJ-45 jack on the rear of the zone’s D5KP Amplified Keypad. See Figure 3.2 for details.

D5KP Rear	D5IP
	Side View

Cat-5

L+ L- R+ R-	- +
SPEAKERS	PWR IN
	Figure 3.2: D5IP to D5KP Connections

External IR Receiver Connections

Use a standard IR Receiver such as Xantech’s 291D Series in areas where a hand-held remote needs to be pointed somewhere other than at the D5KP. Typical IR Receiver locations are near a TV or other equipment such as a Local Source (DVD Player, CD Player, A/V Receiver, etc.). Use a CAT-5 wire to extend the IR Receiver’s cable if necessary and connect the other end to the D5KP. Only three conductors of the CAT-5 will be used. By default, the D5KP External and Internal IR is active. To disable the External or Internal IR, see Section 4.0.

291D SERIES

Internal Wire Colors

White IR OUT

Black GND

Red +12V

D5KP

Figure 3.3: D5KP to External IR Connections

- 14 -