Xantech D5RH Auxiliary Power Connector AUX Power OUT, AUX Power OUT Connections

Auxiliary Power Connector (AUX POWER OUT)

For wire runs over 150’, it is recommended to run an additional 16 AWG/2-conductor wire from the head-end location to the Amplified Keypad locations. This will allow the AUX POWER OUT terminals to supply additional power to the Amplifier Keypads to compensate for the additional distance. For wire runs over 300’, 16 AWG/2-conductor wire is required to operate the keypad. The maximum wire run using CAT-5 and 16 AWG/2-conductor is 600’. Make all connections between the D5RH and the D5KP Amplifier Keypad as previously described, then make the aux power connections described below.

To make connections:

1Ensure that system power is OFF!

2Strip the ends of the 16 AWG wire 1/4" on both ends of the wire run.

3Remove the terminal strip from the AUX POWER OUT connector on the D5RH.

4Loosen the screws for the appropriate zone’s terminal pairs on the terminal strip.

5Insert the wires into the terminal strip, paying close attention to polarity (+/-).

6Tighten the screws on the terminal strip.

7Remove the terminal strip from the PWR IN connector of the D5KP.

8Loosen the screws on the D5KP’s PWR IN terminal.

9Insert the wires into the terminal, paying close attention to polarity (+/-).

10Tighten the screws on the D5KP’s PWR IN terminal.

11Connect the terminal strip back onto the AUX POWER OUT connector on the D5RH.

Figure 3.9: AUX POWER OUT Connections

08905153B - 21 -