HOW TO SET

Your Link 20 automatically selects an appropriate charged voltage for 12-volt liquid and gel cells when you set battery type. (We'll cover setting battery type on page 19). If you operate a 24-volt system, or if extremes of temperature are involved, here's how to change charged voltage:

1.Press SET for five seconds.

2.Press SEL once.

3.Press and hold SET.

4.After 10 seconds, the displayed setting is stored in memory and normal operation resumes.

SEL will appear in the numeric display.

The light will come on and 13.2 will appear in the numeric display.

The numeric display will move up in 0.1 volt steps until 50.0 volts is displayed. The display will then "wrap around" and

start counting up from 8.5 volts. Stop at the desired voltage.

HOW TO SET

The Link 20 is factory set to use 2% of battery capacity as Charging Current Percentage. If you normally end charging before 2% is reached, or use a very large battery bank, such as might be encountered in an alternative energy installation, a different value may be appropriate. Here's how to change it:

1.Press SET for five seconds.

2.Press SEL twice.

3.Press and hold SET.

4.After 10 seconds, the displayed setting is stored in memory and normal operation resumes.

SEL will appear in the numeric display.

The light will come on and 2 will appear in the numeric display.

The numeric display will move up in 1 percent steps until 7 percent is displayed. The display will then "wrap around" and

start counting up from 1 percent.

13