Enabling the Finisher options
Once the Finisher printer driver has been installed on your workstation, you will need to enable the Finisher options. The procedure for doing so varies by operating system. Follow the instructions for the operating system you are running.
NOTE: The procedures in this section apply to the Document Centre ColorSeries 50 copier/printer only. To enable the Finisher options on the DocuColor 12 copier/printer, refer to the product manual supplied by the manufacturer of the Digital Front End connected to your DocuColor 12. The minimum software levels for the Splash and Fiery Digital Front Ends are as follows:
To support the IOT finisher functionality, the Splash G610 system software must be at a minimum of version 2.0.
To support the IOT finisher functionality, the Fiery XP12 and X12 system software must be at a minimum of version 1.1.
Windows 2000
1From the Start menu, select Settings > Printers > Xerox Document Centre CS 50 PS.
2From the File menu, select Properties.
3Select the Device Settings tab.
4Under Installable Options, select Output Tray to display a
5Select Finisher Output Tray + Mailbox.
6Select OK to complete the installation.
6 |
