Overview

Trimmer Mode Settings

 

Tip: Booklets exiting/leaving the SquareFold Trimmer

 

Module may contain trim remnants/scraps from the

 

previously trimmed booklet. This is due to static electricity

 

build-up and is normal. If booklets contain trim

 

remnants/scraps, simply remove and discard them.

 

The Trimmer Mode Settings are found on the SquareFold

 

Trimmer Module control panel. The settings can be switched

 

on or off based on user preference. When the settings are

 

switched on, you can enter a desired setting by pressing the

1.

up/down buttons.

 

2.

 

1.

Trimmer setting up/down buttons

 

Adjustments can be made in 0.1 mm increments by pressing

 

the up/down buttons on the Control Panel.

2.

Trimmer setting

 

The trimmer setting is based on:

• The number of sheets in the finished booklet,

• The finished bookletwidth size (such as 8.5 in./210 mm or 5.5 in/149 mm),

• The media type (coated/uncoated, glossy, etc.), and

• The media weight

Note: Trim settings are always entered using millimeters (mm).

Important!:You may have to experiment with various settings in order to determine the best settings for your particular job. Also, you may want to run one or more test prints/copies before running larger jobs in order to ensure the best possible booklet output.

Note: Trim settings cannot be adjusted to remove less than 2 mm (0.078 in.) or more than 20 mm (0.787 in.) of edge material from the booklet. Adjustments less than 2 mm (0.078 in.) may produce poor trim quality, and adjustments greater 20 mm (0.078 in.) will result in no trimming to the booklet edge.

8

SquareFold Trimmer User Guide

Page 12
Image 12
Xerox SquareFold manual Trimmer Mode Settings