Trouble Recovery
procedure below.
1.Remove the CDI unit cover or electrical cover, if equipped.
2.Disconnect the yellow cord (emergency
circuit) of the CDI unit to return to port.
EWM00350
WARNING
When the yellow cord is disconnected, the idle and low speeds are slightly higher than normal. Use care when starting off or stopping.
ECM00380
CAUTION:
Follow this procedure only in an emergency and just long enough to return to port for repairs.
1
| 1 |
|
|
2 |
| 2 |
|
|
|
| |
|
| ZMU03843 | |
|
|
| |
|
|
|
|
1.CDI unit
2.Emergency connector
EMU29704
Cold engine fails to startIf the engine fails to start when it is cold, use the following procedure.
EWM00410
WARNING
When starting or operating the engine, do not touch the ignition coil, spark plug wire, spark plug cap, or other electrical parts carrying high voltage. Keep loose clothing and other objects away from the engine when starting it. Do not touch the
flywheel or other moving parts when the engine is running.
1.Adjust the trim angle so that the drive shaft is at right angles to the water sur- face or is trimmed in.
2.On models equipped with an emergency starter valve, open it. The valve is locat- ed behind the silencer cover on the front of the engine.
OPEN
CLOSE
ZMU03844
3.Squeeze the primer pump two or three times to feed fuel.
ZMU03142
4.Open the throttle slightly without shifting using the throttle grip, neutral throttle le- ver or free accelerator. It is necessary to change the throttle opening slightly de- pending on the engine temperature. Af- ter the engine starts, return the throttle to its original position.
61