ADJUSTING THE SPEAKER OUTPUT LEVELS
When reproducing a Dolby Surround source using a DSP program such as DOLBY PRO LOGIC or DOLBY DIGITAL ENHANCED, it is necessary to adjust each channel to the same output level in order to bring out the full digital effect of these sound fields. Even when a different DSP program is used, it is possible to bring out the particular flavor of the sound field in question.
Speaker output levels may be adjusted by using the remote control before playback by following the steps.
2 Press TEST.
Test tones (like pink noise) will be output in the
1 | following order. |
|
|
| |
| ● When only the front speaker unit is being used | |
| or the VIRTUAL SURROUND DSP program is | |
| selected: |
|
|
| Front speaker unit |
| LEFT | RIGHT |
LEFT | RIGHT |
SURROUND | SURROUND |
2 | (Virtual) | (Virtual) | |
| |||
| ● When an | ||
|
| Front speaker unit |
|
| LEFT | CENTER | RIGHT |
PREPARATION
1Press p to turn on the power.
If the STANDBY indicator is lit, turn on the power using p on the remote control. If the main power is off (when the STANDBY indicator is not lit), turn on the power by pressing POWER on the front speaker unit.
LEFT |
|
|
| RIGHT |
SURROUND |
|
|
| SURROUND |
|
|
|
|
|
Rear speakers
English
15