REMOTE CONTROL
OPERATING OTHER COMPONENTS USING THE REMOTE CONTROL
Setting the manufacturer code for your TV, VCR or satellite tuner/cable TV on the remote control allows you to operate the front speaker unit and your TV, VCR or satellite tuner/cable TV by remote control. Note that there are two methods for setting the code: manual preset and auto preset.
Notes
•Remote control of some component may not be possible depending on the model and the year of make even though its manufacturer is listed on page i (at the end of this manual).
•Depending on the model in question, some component from other manufacturers cannot be controlled, or only limited functions can be controlled, even though the proper manufacturer code has been set. If you encounter this problem, please use the remote control supplied with the component in question.
•Setting the manufacture code can not be performed if your component to be controlled does not support remote control operation.
Setting the Manufacturer Code
■Using manual preset
4 | Transmission |
indicator | |
| 1 |
| 2 |
3
1Press the remote control selector button (TV, VCR or SAT) for which the manufacturer code is to be set.
The signals for controlling the front speaker unit have already been set for the S70 button so that only the manufacturer code for the TV, VCR or SAT needs to be set. A manufacturer code can be set for a single button if necessary.
2Hold down SET and press c until the transmission indicator lights.
The indicator will light.
3While the transmission indicator is lit, use the numeric buttons to enter the
The indicator will go out. 
The transmission indicator will go out, the code has been set properly. (The code has not been set properly if the indicator flashes and then goes out.)
Refer to page i at the end of this manual for a list of manufacturer codes.
4Press p and check that the component to be controlled turns on and off.
CONTROL REMOTE
English
23