CONNECTIONS

Connect the provided speakers (NX-AV1) to the SPEAKERS terminals on the rear of SW-AV1.

All of the speakers (NX-AV1) are identical. The speakers connected to the FRONT R and L terminals should be used as the right and left front speakers.

The speaker connected to the CENTER terminal should be used as the center speaker.

The speakers connected to the REAR R and L terminals should be used as the right and left rear speakers.

Notes

c Do not connect speakers other than the provided

ones to SW-AV1.

c Use the provided speaker cords for the connections.

Normally, use the short cords to connect with the

front and center speakers, and use the long ones to

connect with the rear speakers.

How to Connect:

Connect the provided speaker cords between the SPEAKERS terminals on the power amplifier/subwoofer (SW-AV1) and the speaker terminals on each speaker (NX-AV1) properly as shown below. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and

–markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.

As a sure method, connect the wire with a silver line to the + terminals on both the power amplifier/subwoofer (SW-AV1) and speaker, and connect the wire with no line to the – terminals on both of them.

Caution

Do not let the bare speaker wires touch each other as this could damage SW-AV1 and/or speakers.

c The provided tag sheet for speaker cords is useful

for preventing wrong connections between speakers

and SW-AV1.

FRONT L

On SW-AV1:

Red: positive (+)

Black: negative (–)

➀ ➂

➁

On NX-AV1:

Red: positive (+)

Black: negative (–)

➀Press up the tab.

➁Insert the bare wire. [Remove approx. 5mm (1/4”) insulation from the

speaker wires.]

➂Press down the tab and secure the wire.

➀Press the tab.

➁Insert the bare wire. [Remove approx. 5mm (1/4”) insulation from the speaker wires.]

➂Release the tab and secure the wire.

E-14