Yamaha AV1 SPEAKER BALANCE ADJUSTMENT

Press the POWER switch to turn the power on.

ADJUSTMENTS BEFORE LISTENING OPERATIONS

SPEAKER BALANCE ADJUSTMENT

	MEMORY AUTO/MAN’L		PRESET/BAND DISPLAY
	VIDEO 2
PUSH	TIME ADJ	TIMER
	/	/	REPEAT
PHONES	HOUR	MIN		/
POWER			OPEN/CLOSE	CD

1

		TRACK PRESET				TIMER SLEEP
						F REP	AUTO ST
						KHz	MEMORY
						MHz	PTY HOLD
RESET/BAND DISPLAY
REPEAT
	/
OPEN/CLOSE	CD	TUNER	TAPE/MD	VCR	VIDEO 1	VIDEO 2		VOLUME

2

			PRESET	4
		TUNER
		CD
	CENTER/REAR		LEVEL
	/DELAY
	C/R/D
3			PROGRAM
	ON/OFF	DSP
4			SUBWOOFER
	TEST
			INPUT
	SLEEP
	POWER	AMP	VOLUME
1				5

2

This procedure lets you adjust the sound output level balance between the front, center, and rear speakers using the built-in test tone generator. When this adjustment is performed, the sound output level heard at the listening position will be the same from each speaker. This is important for the best performance of the built-in Dolby Pro Logic surround decoder.

The adjustment of each speaker output level should be done at your listening position with the remote control transmitter. Otherwise, the result may not be satisfactory.

1

2 Press the VOLUME “–” (or “ ”) button to decrease the volume to minimum until “MIN” is shown on the display.

3 If no DSP program name is illuminated on the display, press the DSP ON/OFF button so that a name of program lights up on the display.

4 Press the TEST button.

* “TEST” appears on the display.

5 Press the VOLUME “+” button to increase the volume.

* Volume level is shown on the display.

You will hear a test tone (like pink noise) from the left front speaker, then the center speaker, then the right front speaker, and then the rear speakers, for about two seconds each. The display changes as shown below.

(L and R)

*The test tone from the left rear speaker and the right rear speaker will be heard at the same time.

E-26