Yamaha CDR200t ♦SCSI ID settings

Chapter 2 - Installing the Yamaha CDR200t Drive

♦SCSI ID settings

The SCSI ID number is used so that the computer will recognize a connected SCSI device. You can assign 0 through 7 as the SCSI ID number. Usually, “7” is reserved for the SCSI card ID number, and “0” is reserved for the first SCSI device in the chain. Use a number between 1 and 6 for the CDR200t. Refer to the diagram below for more information on setting the SCSI ID number. The factory set ID number is “3”.

Important: If you are using other SCSI devices, be sure to use a unique ID number for each device.

Note: When you are using Windows 95, and if the SCSI ID setting on the rear panel is the same as the number assigned to another SCSI device, the Plug and Play component of Windows 95 will automatically assign an unused number to the CDR200t (SCAM protocol level 1).

1 2 4 1 2 4 1 2 4 1 2 4

SCSI ID 0		SCSI ID 1		SCSI ID 2		SCSI ID 3
	1 2 4		1 2 4		1 2 4		1 2 4

SCSI ID 4	SCSI ID 5	SCSI ID 6	SCSI ID 7
	SCSI ID Setting
SCSI ID	ID 1	ID 2	ID 4
0	0 (OPEN)	0 (OPEN)	0 (OPEN)
1	1 (SHORT)	0 (OPEN)	0 (OPEN)
2	0 (OPEN)	1 (SHORT)	0 (OPEN)
3	1 (SHORT)	1 (SHORT)	0 (OPEN)
4	0 (OPEN)	0 (OPEN)	1 (SHORT)
5	1 (SHORT)	0 (OPEN)	1 (SHORT)
6	0 (OPEN)	1 (SHORT)	1 (SHORT)
7	1 (SHORT)	1 (SHORT)	1 (SHORT)

6