Troubleshooting
If CDR200t is not performing as expected, look up the symptoms in the following table, then see what to do.
| Symptoms | What to Do |
|
|
The power to the CDR200t is off | • Check the DC power cable connection. |
|
|
The power to the computer is off | • Check to see if the SCSI card is correctly |
| installed. |
|
|
The CDR200t is not recognized by | • Check the SCSI cable connection. |
the computer. | • Make sure that SCSI ID numbers are assigned |
| |
| exclusively. |
| • Make sure that the last device in the SCSI daisy |
| chain is terminated correctly. |
| |
The CDR200t does not operate cor- • Install the SCSI driver software again. | |
rectly |
|
|
|
The disc tray will not open | • Make sure that the power to the drive is turned |
| on. |
|
|
The disc ejects | • Make sure that the disc is seated in the tray cor- |
| rectly. |
|
|
Incorrect operation | • Make sure that the disc is seated in the tray cor- |
rectly.
• Make sure that you are using the correct disc.
• Make sure that there is no dust, dirt, or condensation on the disc or tray.
13