Yamaha CLP - 820, CLP - 840, CLP - 860, CLP - 860M, CLP - 880, CLP - 880M, CLP - 880PE, CLP-820S Brilliance , The Effect

19

CLP-880/860/840/820/820S

EFFECT

CHORUS

SYMPHONIC

TREMOLO

DELAY

EFFECT

CHORUS

SYMPHONIC

TREMOLO

DELAY SONG

SELECT

–

/

NO

+

/

YES

Brilliance (CLP-880/860/840)

For a brighter or “sharper” tone, slide the control towards the

BRIGHT position. For a “rounder” more mellow tone, slide the control

towards the MELLOW position.

NOTE

•When the BRILLIANCE is set to BRIGHT, the overall sound will be

slightly louder. If the MASTER VOLUME is set at a high level the sound

may become distorted. If so, lower the MASTER VOLUME level.

This control can be used to change the tonality or “timbre” of the sound

output. The control range is from MELLOW to BRIGHT.

BRILLIANCE

BRIGHT

MELLOW

The Effect (CLP-880/860/840)

The [EFFECT] button allows you to select one of the effects that can give

your sound greater depth and animation.

To select an effect type press the [EFFECT] button a few times

until the indicator corresponding to the desired type lights (the indica-

tors light in sequence each time the [EFFECT] button is pressed). No

effect is produced when all indicators are off.

OFF

No effect is selected when no EFFECT indicator is lit.

CHORUS

Shimmering, broadening effect

SYMPHONIC

Adds a deep, symphonic backdrop

TREMOLO

Tremolo effect

DELAY

Echo effect

NOTE

•The default effect type (including OFF) and depth settings are different for

each voice.

Adjusting Effect Depth.............................................................................

Effect depth can be individually adjusted for the selected voice by

using the [–/NO] and [+/YES] buttons while holding the [EFFECT]

button. The depth range is from 0 through 20 (the current depth setting

appears on the LED display while the [EFFECT] button is held). A

setting of “0” produces no effect, while a setting of “20” produces

maximum effect depth. Press the [–/NO] and [+/YES] buttons simulta-

neously while holding the [EFFECT] button to recall the default

setting for the current voice (the default depth settings are different for

each voice).

Contents

Main IMPORTANT CAUTION SPECIAL MESSAGE SECTION USING THE BENCH (if included) SAVING USER DATA PRECAUTIONS PLEASE READ CAREFULLY BEFORE PROCEEDING * Please keep these precautions in a safe place for future reference. WARNING CAUTION Introduction Included Accessories Owners Manual Bench (included or optional depending on locale) Dust Cover (CLP-820S only) Contents The Dual Mode The Split Mode Reverb The Effect The Control Panel Tuning keys (See page 22) PHONES Jacks (Bottom panel) (See page 10) CLP-840 678 9 @ The Control Panel Key Cover & Music Stand Key Cover Key Cover & Music Stand Music Stand To raise the music stand: To lower the music stand: Connections Selecting & Playing Voices Turn Power On Set the Volume Select a Voice Play Playing the Demonstration Tunes Engage the Demo Mode Play a Voice Demo Voice Demo Exit From the Demo Mode Engage the Piano Song Mode Play a Piano Song Piano Song Exit From the Piano Song Mode Piano Song A-B Repeat Specify the Beginning (A) of the Phrase Specify the End (B) of the Phrase Stop Playback Piano Song Part Cancel Turn the Desired Part Off Start/Stop Playback Synchro Start Left Pedal Start/Stop The Dual Mode Other Dual Mode Functions The Split Mode Selecting the Right and Left Voices Setting the Split Point Other Split Mode Functions A-1 b=1 C 2 F~2 Reverb Adjusting Reverb Depth Brilliance The Effect Adjusting Effect Depth The Pedals Soft (Left) Pedal Sostenuto (Center) Pedal Touch Sensitivity Transposition Tuning Tuning Up Z X C Tuning Down The Metronome & Tempo Control The Metronome Metronome Time Signature Metronome Volume Function Tempo Control Using the Recorder Recording Make All Necessary Initial Settings Engage the Record Ready Mode Select the Record T rack Using the Recorder Start Recording Stop Recording Erasing a Single Trac k Changing the Initial Settings Using the Recorder Playback Synchro Start Left Pedal Start/Stop The Function Mode To Select a Function Z X C F1 F2 F2.1: Scale F2.2: Base Note F3 F3.1: Dual Balance F3.2: Dual Detune F3.3: 1st V oice Octave Shift F3.4: 2nd V oice Octave Shift F4.2: Split Balance F4 F4.1: Split Point F4.3: Right V oice Octave Shift F4.4: Left V oice Octave Shift F4.5: Right V oice Effect Depth F4.6: Left V oice Effect Depth F4.7: Damper Range F4.8: Reset F5 F5.1: Left Pedal Mode F5.2: Damper Mode F4 F5.3: Soundboard Depth F6 F5 F7 F6 F8 A Brief Introduction to MIDI MIDI, the Musical Instrument Digital Interface, is a world- F7 F7.1/F8.1: MIDI T ransmit Channel Selection F7.2/F8.2: MIDI Receive Channel Selection F7.3/F8.3: Local Control ON/OFF F7.4/F8.4: Program Change ON/OFF F7.5/F8.5: Control Change ON/OFF F7.6/F8.6: MIDI T ransmit Transpose F7.7/F8.7: Panel/Status T ransmit F7.8/F8.8: Bulk Data Dump F9 F8 F8.2/F9.2: MIDI F8.3/F9.3: Tuning F8.4/F9.4: Pedal Connecting to a Personal Computer Connecting to an Apple Macintosh Series Computer Connecting to an IBM-PC/AT Series Computer Connecting to a Personal Computer IBM-PC/AT Series Computer Set to the PC-2 position. PC-2 Cable Connections 8-pin mini DIN 9-pin D-SUB cable. Data transfer rate: 38,400 bps. Connector Pin Numbers Factory Preset Recall Options & Expander Modules Options Troubleshooting Expander Modules Voice Demo Tune Titles Function Factory Setting List/Liste der Vorgabeeinstellungen/ Liste des rglages/Lista de ajustes de fbrica MIDI Data Format/MIDI-Datenformat/ Format des donnes MIDI/Formato de datos MIDI MIDI Data Format/MIDI-Datenformat/Format des donnes MIDI/Formato de datos MIDI 4. PROGRAM CHANGE Data format: [CnH] -> [ppH] 5. SYSTEM REALTIME MESSAGES 6. SYSTEM EXCLUSIVE MESSAGES (Yamaha MIDI Format) Data format: [F0H] -> [43H] -> [0nH] -> [7CH] -> ... -> Data format: [F0H] -> [7EH] -> [XnH] -> [09H] -> [01H] -> 8. SYSTEM EXCLUSIVE MESSAGES (XG Standard) (1) XG Native Parameter Change Data format: [F0H] -> [43H] -> [1nH] -> [4CH] -> [hhH] -> [mmH] -> [llH] -> [ddH] -> [F7H] (2) XG Native Bulk Data (reception only) Effect MIDI Map MIDI Data Format/MIDI-Datenformat/Format des donnes MIDI/Formato de datos MIDI REVERB EFFECT (CLP-880/860/840) <Table 1> Page CLP-880: Keyboard Stand Assembly X C (D). 4 5 V E N M 8 9 < > ? Page Bundled pedal cord inside Have a Phillips-head (+) screwdriver ready. CLP-860/840/820: Keyboard Stand Assembly DD A B C EE x 6 1 x 4 2 x 2 3 x 4 4 x 4 5 X C (C). V Page 6 7 N M < Have a Phillips-head (+) screwdriver ready. Bundled pedal cord inside CLP-820S: Keyboard Stand Assembly DD A B C EE x 6 1 x 4 2 x 8 3 X C (C). V els (D). Page 6 7 N M < Specifications/Technische Daten/Caractristiques techniques/Especificaciones WARNING- 1. 2.Main Power Supply Verification: Yamaha products are 3. IMPORTANT SAFETY INSTRUCTIONS PLEASE KEEP THIS MANUAL FCC INFORMATION (U.S.A.) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! 2. IMPORTANT: When connecting this product to accessories and/ 3. NOTE: IMPORTANT NOTICE FOR THE UNITED KINGDOM Connecting the Plug and Cord NORTH AMERICA CANADA U.S.A. CENTRAL & SOUTH AMERICA MEXICO