50
CLP-880/860/840/820/820S
4 5
VAttach the front panel (E).
The front panel attaches to the front end of the pedal box and
side panels. Fit the front panel into position and eliminate any
gaps between the front and side panels. Align the small hole in
each six brackets and attach the front panel using the six 4 x 12
millimeter round-head screws 3.
BInstall the main unit (A).
Rest the rear edge of the main unit (A) on the front edges of
the cutouts in the side panels (B), then slide the main unit back-
ward firmly until it stops (so that there is no clearance between
the main unit side panels and the stand, as shown in illustration
“a”). WATCH YOUR FINGERS WHILE DOING THIS!!
There is slight horizontal play between the main unit and side
panels, so center the main unit, as shown in illustration “b”, then
use the four 6 x 16 millimeter flat-head screws 5 to attach the
main unit. Two screws can be attached from the front side and
two screws from the rear.
Do not hold the keyboard in any position other than the position
shown in the above illustration.
Fingers can become pinched between the main unit and the front or
side panels, be extra careful so as not to drop the main unit.

E

10 cm
Be sure to place your hands at least 10 centimeters from
either end of the main unit and position the unit so that it
rests 15 centimeters from the front end of the side panels.
4 x 12 mm round-head screws 3
B
B
10 cm
15 cm
15 cm