168 CVP-103
● Song Copy & Disk Copy
This message appears before you start a Song Copy or Disk Copy operation to inform you
of the number of times the disks must be exchanged. (See page 143.)
This message prompts you to insert the destination disk when copying data from one disk
to another. (See page 143.)
This message appears when you try to copy data from a 2DD disk to a 2HD disk — or vice
versa — using the Disk Copy function (page 142).
➾Press OK to cancel the copy operation, then perform the operation again from the
beginning. Make sure the destination disk you insert is the same type (2DD or
2HD) as the source disk being copied.
This message appears if you insert the source disk when prompted to insert the destina-
tion disk while using the Disk Copy function (page 143) to copy data from one disk to an-
other.
➾Press OK to cancel the copy operation, then execute the Disk Copy function again
from the beginning. When exchanging disks during the copy operation, be careful
not to confuse the source and destination disks.
● Style File Load
This message appears if you attempt to load a Style file when the memory capacity is not
sufficient to hold the specified file. (See page 87.)
Some Style files are too large to be handled by the LISTEN function. (See page 87.)
➾Load the Style file, then use the normal playback methods to hear the style in
question.
● Chord Sequence
This confirmation message appears if you attempt to exit the Chord Sequence function
while recording.
➾Press YES to store the recorded data. Press NO to exit without storing. Press
CANCEL to return to the Chord Sequence function without storing.
This message appears during Chord Sequence recording when you attempt to enter an
accompaniment style or section change at a position other than the beginning of a meas-
ure.
➾Record the style or section change in question at the beginning of the measure.
(See page 122.)
● Other Record Edit
This confirmation message appears if you attempt to exit the Initial Edit function without
writing the data to disk.
➾Press YES to save the edited data. Press NO to exit without saving. Press CANCEL
to return to the Initial Edit display without saving.
This confirmation prompt appears when you execute the Setup Memory function (page
126) to save the current panel settings with the song being edited in Song Record mode.
➾Select YES to save the panel settings. Press CANCEL to return to the RECORD
EDIT 2 display without saving.
Messages
166