112 CVP-509/505/503/501 Owner’s Manual
3
CVP-509/505: Keyboard Stand Assembly
3Attach B and C to A.
1Align parts B and A so that the protrusion fits into the hole.
2Fix the bottom surface of the unit using two long screws.
3Fix the side of the speaker box using two short screws.
If the screw holes do not align, loosen the other screws and adjust
the position of B.
4Fix C in the same way.
4Fix E to D using two short screws.
5Attach D to A.
1Fix D to the bottom surface of A using two short screws.
If the screw holes do not align, loosen the other screws and adjust
the position of D.
6Raise A to the standing position.
Use the front legs as support to raise A.
7Install F.
B
B
A
A
B
Attach the parts, pressing B onto A so that
the two fit tightly together.
A
B
Tighten the screws after
attaching the washers to
the short screws.
DD
EE
CAUTION
• Be careful not to pinch your fingers.
• When you raise the unit, do not hold the key cover.
DDA
2Fix the side of the
speaker box using two
short screws.
AAAA
DD
1Remove the plastic
cover from D.
FF
2Untie and straighten out the
bundled cord attached to
the bottom of F.
DD
F
F
3Pass the pedal cord from
under D to the backside of A.
4Attach F.
Use three thin screws.