CVP-509/505/503/501 Owner’s Manual 117

3
CVP-501: Keyboard Stand Assembly
5Mount A.
Be sure to place your hands at least 10 cm from either end of A when
positioning it.
6Secure A.
7Connect the pedal cord.
8Set the voltage selector and connect the power

cord.

9Set the adjuster.
Rotate the adjuster until it comes in firm contact with the floor sur-
face.
CAUTION
• Fingers can become pinched between A and rear or side pan-
els, be extra careful so as not to drop A.
• Do not hold the keyboard in any position other than the position shown
in the illustration.
R

BD

E

A

At least
10 cm
A
1Center A to produce equal clear-
ance on the left and right sides.
2Use 6 x 16 mm short screws to secure
A from the front.
1Insert the pedal cord plug to the
pedal connector from the rear.
3Attach the cord holders to the
rear panel as shown, then clip
the cord into the holders.
2Use a vinyl tie to take up any
slack in the pedal cord.
WARNING
An improper voltage setting can cause serious damage to the Clavinova
or result in improper operation.

After completing the assembly, please check

the following.
• Are there any parts left over?
→ Review the assembly procedure and correct any errors.
• Is the Clavinova clear of doors and other movable fix-
tures?
→ Move the Clavinova to an appropriate location.
• Does the Clavinova make a rattling noise when you shake
it?
→ Tighten all screws.
• Does the pedal box rattle or give way when you step on
the pedals?
→ Turn the adjuster so that it is set firmly against the floor.
• Are the pedal and power cords inserted securely into the
sockets?
If the main unit creaks or is otherwise unsteady when you play
on the keyboard, refer to the assembly diagrams and retighten
all screws.
When moving the instrument after assembly, always hold the bottom
of the main unit.
CAUTION
Do not hold the key cover or top portion. Improper handling can result in dam-
age to the instrument or personal injury.
Voltage Selector
Before connecting the AC power
cord, check the setting of the volt-
age selector which is provided in
some areas. To set the selector for
110V, 127V, 220V or 240V main
voltages, use a “minus” screw-
driver to rotate the selector dial so
that the correct voltage for your
region appears next to the pointer
on the panel. The voltage selector is
set at 240V when the unit is initially shipped.
After the proper voltage has been selected, connect the AC power
cord to the AC INLET and an AC wall outlet. A plug adaptor may be
also provided in some areas to match the pin configuration of the AC
wall outlets in your area.
Do not hold here.
Hold here.