CVP-509/505/503/501 Owner’s Manual 115

3

CVP-503: Keyboard Stand Assembly

5Fix A.
1Center A to produce equal clearance on the left and right sides.
2Use 6 x 16 mm short screws to secure A from the front.
6Connect the pedal cord.
7Set the voltage selector and connect the power

cord.

Voltage Selector
Before connecting the AC power cord, check the setting of the volt-
age selector which is provided in some areas. To set the selector for
110V, 127V, 220V or 240V main voltages, use a “minus” screwdriver
to rotate the selector dial so that the correct voltage for your region
appears next to the pointer on the panel. The voltage selector is set at
240V when the unit is initially shipped.
After the proper voltage has been selected, connect the AC power
cord to the AC INLET and an AC wall outlet. A plug adaptor may be
also provided in some areas to match the pin configuration of the AC
wall outlets in your area.
8Set the adjuster.
Rotate the adjuster until it comes in firm contact with the floor sur-
face.
WARNING
An improper voltage setting can cause serious damage to the instrument or
result in improper operation.
A
A
1Insert the pedal cord
plug to the pedal
connector from the
front.
3Use a vinyl tie to take up any
slack in the pedal cord.
2Attach the cord holders to D as
shown, then clip the cord into the
holders.

After completing the assembly, please check

the following.
• Are there any parts left over?
→ Review the assembly procedure and correct any errors.
• Is the Clavinova clear of doors and other movable fix-
tures?
→ Move the Clavinova to an appropriate location.
• Does the Clavinova make a rattling noise when you shake
it?
→ Tighten all screws.
• Does the pedal box rattle or give way when you step on
the pedals?
→ Turn the adjuster so that it is set firmly against the floor.
• Are the pedal and power cords inserted securely into the
sockets?
If the main unit creaks or is otherwise unsteady when you play
on the keyboard, refer to the assembly diagrams and retighten
all screws.
When moving the instrument after assembly, always hold the bottom
of the main unit.
CAUTION
Do not hold the key cover or top portion. Improper handling can result in dam-
age to the instrument or personal injury.
Do not hold here.
Hold here.