Part Names and Functions
■Using the remote control
Use the remote control under the following conditions. The remote control will not function if it is used outside the angles and/or range detailed here.
Usable distance | Usable angle |
|
7 m (23 feet) | 30 degrees |
|
|
|
|
A left/right arc of 30 degrees | A vertical arc of 30 degrees | |
INTRODUCTION
7 m (23 feet) | 7 m (23 | feet) |
|
|
7 m
(23 feet)
Important
•Bright light, fluorescent light etc. on the remote sensor on the main unit may inhibit the normal functioning of the remote control.
•The remote may not function normally if there is an obstacle blocking the signal between the remote and the remote control sensor on the main unit.
•The above are approximate figures.
■Loading the batteries into the remote control
1
3
2
■Using the remote as a wired remote
control
To use the remote control as a wired remote control, use a 2P monaural miniplug to connect the remote control cable jack on the underside of the remote control to the REMOTE IN jack on the main unit.
MENU-2
ID
|
|
| STILL | INPUT |
| VID | EO | A | HIDE |
|
| |||
1 |
|
| B | DVI |
4 |
| 2 |
| D4 |
5 |
|
| 3 |
|
RESET |
|
| 6 |
|
1.Remove the battery compartment cover from the back of the remote control.
2.Insert two batteries (AA, UM3, or R6 type), matching the polarity markings (+,
3. After inserting the batteries, close the cover until it snaps into place.
Important
• If the remote must be used closer to the main unit than normal, or does not always operate correctly, exchange the batteries for new ones.
•Do not mix old and new, or different types of battery.
•Remove the batteries if you do not plan to use the unit for a long time.
•If the batteries leak, dispose of them immediately, taking care not to touch the battery fluid. If the battery fluid comes into contact with your eyes, mouth, or skin, rinse it off with water immediately and consult a doctor. Clean the battery compartment thoroughly before installing new batteries.
English