Additional information
■ Message display
Message | Condition |
|
|
No Signal | The unit is not receiving or detecting any signal at the selected input source. This message is displayed |
| together with the name of the input source selected with the INPUT button. |
|
|
INPUT A (Component) (Example) | The input name selected by the INPUT button is displayed. It will turn off 1 minute after the signal has |
| been input. |
|
|
Out Of Range | The unit is not able to decode the PC signal currently being input. |
|
|
Unknown Format | The unit is not able to decode the video signal currently being input. |
|
|
Auto Sync... | The unit is setting itself to the most appropriate configuration for the RGB signal currently being received. |
|
|
Memory | The memory setting number is displayed for 2 seconds. |
|
|
The lamp needs to be replaced. Please | This message is displayed when the power switch is turned on if the lamp running time exceeds 2000 hours. |
replace the lamp you are currently | Press the ESCAPE key to remove the message. |
using with a new one. |
|
|
|
Press again for standby. | Press the STANDBY/ON button once more to place the unit in standby mode. |
|
|
Squeeze (Example) | The name of the display aspect mode selected with the ASPECT button is displayed for 2 seconds. |
|
|
Lens Adjustment is locked. | Displayed when the “LENS ADJUSTMENT LOCK” is set to “ON”. This message will display for 2 |
| seconds if you press the V. POS, ZOOM, or FOCUS buttons when the “LENS ADJUSTMENT LOCK” is |
| set to “ON”. |
|
|