Basic Operations

This section describes the basic operation of the DPX-1000 once installation and connection have been completed. It is necessary to make detailed settings in the menu described later so that the DPX-1000 is correctly set for the mounting, screen, input signals, and other conditions of its installation. Follow the steps described in this section to carry out these procedures.

■Turning on the power

Be sure to remove the lens cover before using this unit.

1.Plug the supplied power cord into the AC inlet on the rear of the DPX-1000, then plug the cord into the wall outlet. The STANDBY/ON indicator will turn orange.

STANDBY/ON

STANDBY/ON indicator

ESCAPE

MENU

PATTERN

SETTING

■Turning off the power

1.Press the STANDBY/ON button when finished using this unit.

There will be a message to confirm that you wish to turn the unit off. Press the STANDBY/ON button once more to confirm that you wish to do so. The lamp will switch to a half-lit state, and the fan continues for roughly 2 minutes to cool the lamp. During this time, the STANDBY/ON indicator blinks orange. You cannot turn the unit on again by pressing the STANDBY/ ON button during this time.

ASPECT

INPUT

LAMP COVER TEMP FAN

Press again for standby

AC inlet

2.Press the STANDBY/ON button (The button on the remote control). The indicator will blink green and the lamp inside the unit will light up, in preparation for projection.

STANDBY ON ( )

STANDBY/ON indicator

AUTO

STANDBY/ON

V. POS

ZOOM

FOCUS

IRIS SETTING PATT

ESCAPE

MENU

ESCAPEMENU

PATTERN SETTING

ASPECT

INPUT

◆ Note ◆

•The lamp may blink when in the half-lit state. This is not a lamp failure.

2. Once cooling is completed, the STANDBY/ON

BASIC

indicator will cease blinking, becoming a steady

 

orange.

 

 

 

OPERATION

orange. This could damage the lamp and result in

 

Important

 

 

• Do not disconnect the power cord when the fan is

 

 

going and the STANDBY/ON indicator is blinking

 

 

shorter lamp life or lamp failure.

 

 

 

 

 

3. Replace the lens cover and disconnect the unit from

the power outlet if you do not plan to use it for a long

LAMP COVER TEMP FAN

◆ Note ◆

ASPECTINPUT

time.

•There are STANDBY/ON indicators located on the front panel and the control panel of the main unit.

3.After approximately 35 seconds, the indicator will stop blinking, indicating that preparations for projection are complete.

Important

•Be sure not to disconnect the power cord while the power STANDBY/ON indicator is green, or blinking green. This can cause significant damage to the lamp and may result in a shorter lamp life or failure.

Important

•Condensation may appear on the unit if the temperature of the surround environment changes quickly. Condensation may also cause the projected image to be cloudy. Switch off the unit power until the condensation disappears. Switching the unit on when condensation is present may damage the unit.

English

E-11