CONNECTING SPEAKER SYSTEMS
Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and – markings are observed. If these wires are reversed, the sound will be unnatural and will lack bass. Do not let the bare speaker wires touch each other or any other metal part as this could damage this unit and/or speakers.
NOTE: Use speakers with the specified impedance shown on the rear of this unit.
For connecting to the MAIN and CENTER SPEAKERS terminals.
| Red: positive (+) |
2 | Black: negative |
| |
1 | ➀ Unscrew the knob. |
| ➁ Insert the bare wire. |
| [Remove approx. 5mm (1/4”) |
3 | insulation from the speaker |
| wires.] |
| ➂ Tighten the knob and |
| secure the wire. |
NOTE: Banana Plug connections are also possible (except for Scandinavian models). Simply insert the Banana Plug connector into the corresponding terminal.
For connecting to the REAR SPEAKERS terminals.
| Red: positive (+) | |
➁ | Black: negative | |
| ||
| ➀ Press down the tab. | |
➂ | ➁ Insert the bare wire. | |
[Remove approx. 5mm (1/4”) | ||
| insulation from the speaker | |
➀ | wires.] | |
➂ Press up the tab and secure | ||
| ||
| the wire. |
12