TROUBLESHOOTING
| PROBLEM | POSSIBLE CAUSE | WHAT TO DO |
Power does not come on. | AC cord not properly plugged in. | Carefully plug AC plug into outlet. |
|
|
|
Hum. | Bad cable connection. | Firmly plug in all connection cables. |
|
|
|
No sound. | Bad or incorrect input connection. | Check connections. |
| Incorrect input source selection. | Select the appropriate input source with the input selector switch. |
No sound from the effect speakers.
The EFFECT switch is set off.
The DOLBY PRO LOGIC program is being used with material not encoded with Dolby Surround.
Press the EFFECT switch to turn on. Use a different sound field program.
No sound from the center speaker. | The center mode is in “PHNTM”. | Select the appropriate center mode. |
| Incorrect sound field program. | Select the appropriate program. |
|
|
|
The sound suddenly goes off. | The protection circuit has activated because of | Turning the unit off and then on will reset the protection circuit. |
| short circuit etc. |
|
|
|
|
The volume level cannot be increased, | The power to the component connected to the | Turn the power to the component on. |
or sound is distorted. | REC OUT jacks of this unit is off. |
|
|
|
|
DSP parameters or other settings on this | The “MEMORY GUARD” function is | Turn the “MEMORY GUARD” OFF. |
unit cannot be changed. | set ON. |
|
Left rear and right rear channels not | This is normal operation and is an exact |
|
balanced in certain digital sound field | duplication of the actual data which was |
|
programs. | measured for that particular hall etc. |
|
The sound field cannot be recorded. | It is not possible to record the sound field on a |
|
| tape deck connected to this unit’s TAPE |
|
| REC OUT jacks. |
|
|
|
|
The remote control unit does not function | Dead batteries. | Replace batteries. |
properly. | Wrong distance or angle. | The remote control unit will function from a maximum range of 7 |
|
| meters, no more than 30 degrees |
Direct sunlight or lighting (of an inverter type of flourescent lamp etc.) is striking the remote control sensor of the main unit.
Change position of the main unit.
Noise from nearby TV or tuner.
This unit is too close to the affected equipment.
Move the unit further away from the affected equipment.
37