1Audio Signal Connection Jacks (for Audio Source Equipment) Connect the inputs and/or outputs of your audio equipment.

2Audio/Video Signal Connection Jacks (for Video Source Equipment)

Connect the audio and video inputs and/or outputs of your video equipment. In place of the VIDEO jacks, the S VIDEO jacks can be used for higher resolution and improved picture quality if your VCR, monitor, etc. are equipped with S-VIDEO connectors.

3Front Effect Out Jacks

Front-channel line output. Not connected when the built-in amplifier is used. Can be connected to input jacks of an external stereo power amplifier driving the front effect speakers.

4Rear Effect Out Jacks

Rear-channel line output. Not connected when the built-in amplifier is used. Can be connected to input jacks of an external stereo power amplifier driving the rear effect speakers.

5Main Speaker Terminals

When using this unit’s built-in main-channel amplifier, connect the main speakers here.

6Front Effect Speaker Terminals

When using the built-in front-channel amplifier, connect the front effect speakers here.

7Center Speaker Terminals

When using the built-in center-channel amplifier, connect one or two center speakers here.

8Center Speaker Impedance Switch

Set to “A + B” when using two center speakers, or to “A or B” when using only one center speaker.

9Rear Effect Speaker Terminals

When using the built-in rear-channel amplifier, connect the rear effect speakers here.

0GND Terminal

Connects the ground wire of the turntable to produce minimum hum. In some cases, however, better results may be obtained with the ground wire disconnected.

AVideo NTSC/PAL Switch (General Model only)

Set this switch to the position corresponding to the standard that your video equipment employs.

BFront Mix Switch

Set to “OFF” when setting up a full 7 or 6 speaker system, or to “ON” when setting up a 5 or 4 speaker system.

CMain Level Switch

Normally set to “0 dB”. If desired, you can decrease the main- channel output level at the MAIN speaker terminals by 10 dB by setting this switch to “–10 dB”.

DLow Pass Jack

When using a subwoofer, connect its amplifier input to this jack. Frequencies below 200 Hz from the left main, right main and center channels are output to this jack.

English

11