Yamaha DSP-AZ1 ■Summary of SPEAKER SET items 1A through 1G, ■Mode setting, SPEAKER MODE SETTINGS

SPEAKER MODE SETTINGS

This unit has seven SPEAKER SET items in the SET MENU that you must set according to the number of speakers in your configuration and their size. The following table summarizes these SPEAKER SET items, and shows the initial settings as well as other possible settings. If the initial settings are not appropriate for your speaker configuration, change the settings in the SET MENU.

■Summary of SPEAKER SET items 1A through 1G

		Control value (default
Item	Description	setting indicated in bold)
1A CENTER SP	Selects the output mode according to whether or not a center speaker is being used and its	LRG/SML/NONE
	performance.
1B MAIN SP	Selects the output mode according to the performance of the main speakers.	LARGE/SMALL
1C REAR L/R SP	Selects the output mode according to whether or not rear L/R speakers are being used and	LRG/SML/NONE
	their performance.
1D REAR CT SP	Selects the output mode according to whether or not a rear center speaker is being used and its	LRG/SML/NONE
	performance.
1E LFE/BASS OUT	Selects the speaker according to use for LFE signal output and low bass signal.	SW/MAIN/BOTH
1F FRONT EFCT SP	Selects the output mode according to whether or not front effect speakers are being used.	YES/NONE
1G MAIN LEVEL	Selects the main speaker level.	Normal/–10dB

Cautions

•When you select 6CH INPUT as the input source, settings of “1 SPEAKER SET” on the SET MENU do not apply (except for “1G MAIN LEVEL”).

•When the digital signals with over 96 kHz sampling frequency are input, only the “1G MAIN LEVEL” setting is effective.

■Mode setting

Adjustment should be made with the remote control.

1 Set PARAMETER/SET MENU to SET MENU.

PARAMETER

SET MENU

2 Select “1 SPEAKER SET” on the SET MENU.

Press / on the remote control to display the SET MENU on the monitor. Press / repeatedly to select “1 SPEAKER SET” on the SET MENU.

	SET	MENU 1/5
≥ 1	SPEAKER SET
2	LOW FREQ.TEST
3	HP	TONE CTRL
4	CENTER GEQ
	/	: Up/Down
	-/+	: Enter

3 Enter the setting mode.

Press +/– on the remote control to enter the setting mode. The current setting is shown on the front panel display and the video monitor. Select the item (1A – 1G) to be set by pressing / on the remote control.

1A CENTER SP

“LRG SML NONE

4 Change the setting.

Press +/– on the remote control repeatedly to change the setting for the selected item.

5 Close the SET MENU.

Press / repeatedly until the DSP program name appears to close SET MENU or press one of the DSP program buttons on the remote control.

HALL 1	HALL 2	CHURCH	JAZZ CLUB
1	2	3	4
ROCK	ENTER–	CONCERT	CONCERT
CONCERT	TAINMENT	VIDEO 1	VIDEO 2
5	6	7	8
TV	MOVIE	MOVIE	/DTS
THEATER	THEATER 1	THEATER 2	SUR.
9	10	11	12
	0	+10	+100

Note

•This setting operation can be done by using NEXT and SET MENU +/– on the front panel.

E-34