REMOTE CONTROL FEATURES

Programming a new remote control function (Learn feature)

If you want to program functions not included in the basic operations covered by the manufacturer code, or a manufacturer code is not available, the following procedure needs to be performed. The possible programming area is the same as a component control area, so the buttons are programmable independently for each source component area.

MACRO

TRANSMIT RE–NAME CLEAR LEARN MACRO OFF ON

SYSTEM

POWER STANDBY V–AUX TUNER PHONO

CABLE

SAT

MD/TAPE

CD–R

CD

D–TV/LD

VCR 1

VCR 2

VCR3/DVR

DVD

 

 

 

 

6CH INPUT

4, 8

2

Cautions

•If you do not press any button within 30 seconds during steps 5 and 6, the learning process is canceled. If this happens, start over from step 4.

•Do not press and hold LEARN longer than 3 seconds. Otherwise this unit enters the manufacturer code setting mode.

 

 

TITLE

 

 

 

 

 

ENTER

 

SOURCE

 

 

 

 

DISPLAY

MENU

 

SOUND

SELECT

SEARCH

CHAPTER

POWER

REC

STOP

PAUSE

PLAY

10KEY DSP

HALL 1

HALL 2

CHURCH

JAZZ CLUB

1

1

2

3

4

ROCK

ENTER–

CONCERT

CONCERT

 

CONCERT

TA NMENT

V DEO 1

V DEO 2

1 Set 10KEY/DSP to 10KEY.

10KEY DSP

5 Press the button for which you want to program the new function.

“LEARN” is displayed.

6 Press and hold the button on the other remote control that has the function you want to program into this remote control until “OK” appears in the display window.

Cautions

•“NG” appears in the display window when programming has not been done correctly. In this case, start over from step 5.

Caution

•It is also possible to program in the control area of this unit with 10KEY/DSP set to DSP. However, if you program functions in this area, you cannot control this unit and select a DSP program.

2 Press an input selector button to select a source component.

3 Place this remote control and the other remote control about 5 to 10 cm apart on a flat surface so that their infrared transmitters are aimed at each other.

 

TV/LD–D

CABLE

SYSTEM POWER

TRANSMIT

TITLE

VCR3/DVR 2 VCR 1 VCR

R–CD MD/TAPE SAT

TUNER AUX–V STANDBY

MACRO LEARN CLEAR NAME–RE

INPUT 6CH

DVD

CD

PHONO

MACRO ON OFF

5 to 10 cm (2 to 4 inch)

4 Press LEARN by using a ballpoint pen or similar object.

“LEARN” and the selected component name appear alternately in the display window.

LEARN

LEARN

•When the memory is full, “FULL” appears in the display window, and this remote control cannot acquire any more functions. Clear unnecessary programmed functions to allow the unit to acquire new functions.

7 Repeat steps 5 and 6 to program additional func- tions.

8 Press LEARN again to exit from the learning mode.

LEARN

Cautions

• Learning may not be possible in the following cases:

1when the batteries in the remote control for this unit or other component are weak

2when the distance between the two remote controls is too much or too little

3when the remote control infrared windows are not facing with appropriate angle

4when the remote control is exposed to the direct sunlight

5 when the function to be programmed is continuous or uncommon

•“ERROR” appears in the display window in the following circumstances:

1 when pressing more than one button at once

2 when MACRO ON/OFF is switched to another position

DVD

E-68