REMOTE CONTROL FEATURES

Clearing learned functions, macros, renamed source names, and setupmanufacturer codes

You can reset the remote control to its factory setting by clearing the changed Libraries, programmed macros, set manufacturer codes and learned functions.

1, 3, 4

 

 

 

MACRO

TRANSMIT RE–NAME CLEAR LEARN

MACRO

OFF ON

SYSTEM

STANDBY

V–AUX

TUNER

PHONO

POWER

CABLE

SAT

MD/TAPE

CD–R

CD

D–TV/LD

VCR 1

VCR 2 VCR3/DVR

DVD

 

 

 

 

6CH INPUT

 

 

TITLE

 

2

 

 

 

ENTER

 

 

 

 

SOURCE

 

 

 

 

 

DISPLAY

MENU

 

SOUND

SELECT

SEARCH

CHAPTER

POWER

REC

STOP

PAUSE

PLAY

3 Press and hold CLEAR again for about 3 seconds.

“C:OK” appears in the display window.

CLEAR

C:OK

 

Caution

“C:NG” appears in the display window if the operation is unsuccessful. In this case, start over from step 2.

4Press CLEAR to exit from the clearing mode.

Once you have cleared a learned function or macro for a button, the button reverts to the factory setting.

1Press CLEAR by using a ballpoint pen or similar object.

CLEAR

CLEAR

 

Caution

If you do not press any button within 30 seconds after step 1, the clearing process is canceled. If this happen, start over from step 1.

2Press / to select the clear mode.

ENTER

There are six clearing modes as shown below.

L:(name of a component) :

Clears all learned functions for the component area. Press the input selector button to select the compo- nent.

L:AMP : Clears all learned functions for this unit control area.

L:ALL : Clears all learned functions.

M:ALL : Clears all programmed macros.

RNAME : Clears all renamed source names in the display window.

FCTRY : Clears all programmed functions including setup manufacturer codes. This returns to the factory settings.

CLEAR

Caution

“ERROR” appears in the display window under the following circumstances:

1 when pressing a button other than the cursor and ENTER 2 when pressing more than one button at once

3 when MACRO ON/OFF, 10KEY/DSP or PARAMETER/ SET MENU is switched to another position

E-80