56

2-8. Dump Interval

This sets the length of intervals between the packets of MIDI data
sent by the DTXPRESS Bulk Out function. The intervals can be
adjusted to the capacity of the external receiving MIDI device to
prevent data overflow.
q DumpInterval (Dump Interval)
[Range] 50, 100, 150, 200, 250, 300 (in msec.)

2-9. Send Hi-Hat Control

This sets whether or not hi-hat controller events will be transmit-
ted from the MIDI OUT jack or TO HOST jack.
q Send HH Ctrl (Send Hi-Hat Control)
on: Sends data to the MIDI OUT jack and TO HOST jack.
off:Does not send data to the MIDI OUT jack and TO HOST
jack.
*This setting does not affect internal operating data for the hi-hat
controller.

2-10. Host Thru Port

This enables the DTXPRESS to transmit multi-port type messages
received from the TO HOST jack. Only messages corresponding
to the set port number will be sent via MIDI.
*This setting only has affect when the TO HOST switch is set to
a position other than “MIDI”.
UT MIDI SETUP
DumpInterval=100 q
UT MIDI SETUP
Send HH Ctrl= on
q Host Thru Port
Assigns the Port Number (1-8).
UT MIDI SETUP
Host Thru Port=1 q

3. Sequencer Group

This sub-mode contains settings that relate to the sequencer (song).
This group is divided into the following 8 pages.
3-1. Click Voice ....................................................... 56
3-2. Click Tune ........................................................ 57
3-3. Click Note Number .......................................... 57
3-4. MIDI Control .................................................... 57
3-5. Count Switch ................................................... 57
3-6. Sync Mode ...................................................... 57
3-7. Use Tempo ...................................................... 58
3-8. Click Mode .......................................................58

3-1. Click Voice

This function sets each of the 3 click voices used for the click
sound. Drum voices are assigned.
Utility Mode
q Click (Click Voice)
Select and set the Click Voice for the click sound.
hi: Used for the click at the beginning of the measure.
mid: Used for quarter note beats.
lo:Used for other clicks for notes of smaller quantization.
w Voice Category
[Range] K, k, S, s, T, t, C, H, P, E, e, L, m
Sets the voice to be used for the Click Voice selected in step q
Click, select a drum voice category.
Refer to Drum Kit Voice Edit Mode’s [1-1. Voice] (P. 41).
e Voice Number Voice Name
[Range] 0, 1-127
Selects the voice that will be assigned. The Voice Number (1-127)
and Voice Name will be displayed.
If this parameter is set to “0”, “NoAssign” will appear on the
display and sound will not be produced.
* Refer to the [Drum Voice List] (P. 68).
UT SEQ Click= hi
=P/053 MtBel
w e
q
q