Yamaha DTXPRESS Rear Panel, Controls and Functions

!7 Page Button [PAGEs, PAGEt]

These buttons are used to navigate through the display pages. The

[PAGEs] button moves to the next page while the [PAGEt] but-

ton moves to the previous.

Hold the button to continuously move through the pages. Hold the

[SHIFT] button and press the [PAGEs] button to mute the drum

voice during playback (Rhythm Mute Function).

Hold the [SHIFT] button and press the [PAGEt] button to dis-

play the Song Tempo Setting (P. 18)

@0 MIDI IN/OUT Jack

These jacks are for the transmission and reception of MIDI data to

and from external MIDI devices.

Connecting external MIDI devices will expand the function of the

DTXPRESS.

@1 Input Attenuation Switch

(INPUT ATTENUATION)

Sets the general Input Attenuation for each Trigger Input Jack (1

KICK-6 RIDE). Lowering the switch (L) lowers the attenuation.

Raising the switch (H) increases attenuation. This adjusts the in-

put level to meet the specification of pads and trigger sensors con-

nected to the DTXPRESS. (P. 10)

@2 Trigger Input Jack (1 KICK-8HI HAT)

Connect pads and trigger sensors to these jacks. Connect pads ac-

cording to the indication below each input. (P. 10) Stereo output

pads are also compatible with the DTXPRESS.

@3 Trigger Input Jack (9/10)

Used to connect a pad to the DTXPRESS. The stereo jack’s L

corresponds to input 9, R corresponds to input 10. Using a stereo

phone plug to connect two pads makes two-trigger input possible.

If a monaural phone plug is used, only input 9 is available for use.

@4 Hi-Hat Controller Jack (HI HAT CONTROL)

This jack is used to connect a hi-hat controller (P. 10).

* Use a cable with a stereo plug when connecting a Hi-hat controller.

Rear Panel

@5 Host Select Switch

(HOST SELECT Mac/PC-1/PC-2/MIDI)

Set the switch according to the type of computer connected to the

TO HOST jack @6. If the MIDI jack is used set the switch to the

“MIDI” position. (P. 12, 26)

@6 TO HOST Jack

This jack is used to connect a computer to the DTXPRESS with a

serial cable. Use a cable that is compatible with the type of com-

puter you are using. (P. 26)

@7 Output Jacks (OUTPUT L/MONO, R)

These jacks are used to connect the DTXPRESS to an external

amplifier, mixer, etc. For monaural playback use the L/MONO

jack. For stereo playback connect both L/R jacks.

@8 Power Supply Jack (DC IN 12V)

Connect an AC adaptor to this jack. To prevent the adaptor from

becoming unplugged, secure the cord to the cord hook @9.

@9 Cord Hook

Prevents the power cord from accidentally becoming unplugged.

(P. 13)

!8 Select Button [SEL<, SEL>]

Use these buttons to move the cursor.

Hold the [SHIFT] button and press the [SEL>] button to switch

to the “Groove Check Function”. (P. 17)

!9 Value Button (VALUE–, VALUE+)

Changes the data value selected with the cursor.

Hold the button to continuously change the value.

Hold the [VALUE+] button and press the [VALUE–] button to

increase the value by 10 continuously.

Hold the [VALUE–] button and press the [VALUE+] button to

decrease the value by 10 continuously.

Controls and Functions

@0 @1

@4 @5 @6 @7 @8 @9