1 DISPLAY
2
MODE 
PTY SEEK 
START
REPEAT TIME MEMORY
HOUR | MIN | TIME ADJ |
Changes.
3
MODE 
PTY SEEK 
START
REPEAT TIME MEMORY
HOUR | MIN | TIME ADJ |
Changes.
1 While the power is on, press the DISPLAY button to display the time. If this unit is in the standby mode, you can proceed to the next step.
2 While holding the TIME ADJ button pressed, press the HOUR button and set the hour.
*Press the HOUR button once to advance the time by 1 hour. Press and hold to advance continuously.
3 While holding the TIME ADJ button pressed, press the MIN button and set the minute.
*Press the MIN button once to advance the time by 1 minute. Press and hold to advance continuously.
In the event of a power failure or when the AC supply lead is disconnected.
The time display will go out, however, the clock will function for about 5 minutes without power supply. So you do not have to reset the time if the AC power supply is resumed within about 5 minutes.
When the AC power supply is resumed after more than 5 minutes pass without power supply, the time display will flash on and off to indicate that the time must be reset.
English
If desired, you can adjust brightness of the display.
1 Press and hold the DISPLAY button for more than 2 seconds so that “DIMMER±0” appears on the display.
2 Holding the DISPLAY button pressed, turn the VOLUME control clockwise to increase or counterclockwise to decrease brightness.
This adjustment can be made even though this unit is in the standby mode.
Control range
When the power is on: ±0 to
When this unit is in the standby mode : +3 to
value: ±0)
VOLUME
VOLUME
VOLUME
Front panel operation
Rotate the VOLUME control clockwise to increase the volume, and counterclockwise to decrease the volume.
Remote control operation
Press the VOLUME + button to increase the volume and the VOLUME – button to decrease the volume.
*Adjusted volume level is shown by the volume level meter and in figures on the display.