HOW TO USE THE BUILT-IN TIMER

2-➁ 2-➀

 

 

 

 

INPUT SELECTOR

 

VOLUME

 

 

 

 

VCR/LD-TV/CD/TUNER/TAPE•MD/AUX

 

 

 

CD CHANGER RECEIVER EMX–100RDS

 

 

 

 

 

 

 

 

 

 

OPEN/

 

 

 

 

 

 

 

CLOSE

 

 

 

 

 

 

 

DISC

 

 

 

 

 

 

 

CHANGE

 

 

 

 

 

DISC

 

 

 

 

 

 

1

2

3

 

 

 

 

 

 

 

 

 

RANDOM REPEAT

TIME

MEMORY

AUTO/MAN'L

 

 

PROGRAM

 

 

 

 

 

 

 

 

 

HOUR

MIN

TIME ADJ

TIMER

STANDBY/ON

 

 

 

PRESET/TUNING/BAND

A/B/C/D/E

 

 

 

 

MUSIC

 

 

 

 

PHONES

 

 

 

 

MIC

 

MIC MIXING

 

 

USER

MEMORY

DISPLAY

 

 

 

MIN MAX

2

 

 

CD

 

 

 

1

2

3

4

5

 

1

2

3

4

5

 

6

7

8

PRESET

 

6

7

8

9

0

 

A

B

C

D

E

 

TIME

PROG

 

 

+I0

 

MODE

REPEAT

RANDOM

OPEN/CLOSE

TUNER

2-➁

DISC SKIP

 

 

STOP

PLAY/PAUSE

 

 

 

INPUT

 

2-➁

CENTER/REAR

TEST

FLAT

 

 

/DELAY

 

 

 

LEVEL

MUSIC

PROGRAM

USER

 

SLEEP

STANDBY/ON

DISPLAY

 

 

 

 

 

VOLUME

Timer play

By using the built-in timer, you can set the time when the unit turns on and a source begins playing automatically, and the time when the unit turns into the standby mode automatically.

1 Prepare the source to be played.

For tuner:

Tune in to the station you will listen to.

For CD player:

Load a disc on the disc table. If more than one disc are loaded on the disc table, select the disc by using the DISC selector buttons or the DISC SKIP button.

2 Press the DISPLAY button.

Whenever the DISPLAY button is pressed, the display mode changes as follows.

On each mode, make a setting for the timer play, following the setting procedure described below.

→ ➀ Current time (TIMER on/off mode)

→ ➁ Source selecting mode (TUNER, CD)

→ ➂ ON TIME/Time setting mode → ➃ OFF TIME/Time setting mode → ➄ Normal display mode

Note

The display mode will be changed to the next mode after about 8 seconds elapse in turn automatically. If the mode is changed before the setting is completed, call the mode again by pressing the DISPLAY button once or more.

Setting procedure:

➀Current time

Check to be sure that the current time is correct, and press the TIMER button so that “TIMER” lights up on the display.

➁Source selecting mode

Select the source (TUNER or CD) to be played with the INPUT SELECTOR.

*If “TUNER” is selected, soon it is changed to the frequency display mode. In this mode, you can select the station to listen to by the timer play by

using the PRESET/TUNING/BAND selector button,

A/B/C/D/E button and / buttons.

English

CONTINUED

E-39