Manuals / Brands / Home Audio / CD Player / Yamaha / Home Audio / CD Player

Yamaha EMX120CD (1), (2), (4), (3), Antenna connection, Note, Notes, or FM 75Ω, Earth rod, 15 m (49 feet), (1) Supplied FM antenna, (3) External FM antenna

1 53

Download 53 pages, 1.12 Mb

CONNECTIONS

ANTENNA

(1)

AM

GND

FM 75Ω

UNBAL.

(2)

ANTENNA

AM

GND

FM 75Ω

UNBAL.

15 m (49 feet)(4)

(3)

7.5 m (25 feet)

Antenna connection(1) Supplied FM antenna

Connect the FM antenna wire to the corresponding terminal and direct the FM antenna wire to the direction where the strongest signal can be received.

(2) Supplied AM loop antenna

Connect the AM loop antenna wires to the corresponding terminals. Position the AM loop antenna for optimum reception. Place the AM loop antenna on a shelf etc., or install it on the rack or wall with screws (not supplied).

Notes

•When static is still heard even after adjusting the position of the AM loop antenna, try reversing the wire connections (from the upper terminal to the lower one, and vice versa).

•Do not place the AM loop antenna on the unit. It will result in noise generation, since the unit is equipped with digital electronics. Place the AM loop antenna away from the unit.

(3) External FM antenna

Use an external FM antenna instead of an indoor FM antenna if you need better reception. Consult your dealer.

(4) External AM antennaUse an external AM antenna if you need better reception. Consult your dealer.

Note

When using an external AM antenna, be sure to keep the wire of the AM loop antenna connected.

English

ANTENNA

AM

GND

or FM 75Ω

UNBAL.

Earth rod

			ANTENNA
		AM
		GND
EO SIGNAL		FM	75Ω
EO SIGNAL		FM	UNBAL.
	VCR	MONITOR
		OUT		FREQUENCY
N	OUT	CENTER		FREQUENCY
		MODE		STEP
		NORMAL		100kHz
		NORMAL		50kHz
				FM

FREQUENCY STEP switch (General model only)

Because the interstation frequency spacing differs in different areas, set the FREQUENCY STEP switch (located at the rear) according to the frequency spacing in your area. Before setting this switch, disconnect the AC supply lead of this unit from the AC outlet.

E-11

Contents

Page SUPPLIED ACCESSORIES ACCESORIOS INCLUIDOS KHz MHz 90 A B C D E F G H I J K L M N OP Q R S T U V W MN O P Q 0.2 m – 6 m (8” – 20’) Center speaker Altavoz central Rear speakers Altavoces traseros Front speakers White line Linea blanca (General model) (Modelo General) LD player etc Monitor TV Tocadiscos de discos láser, etc Monitor de TV Tape deck, MD recorder, etc INTRODUCTION CONTENTS Page PRECAUTIONS OPERATING EXTERNAL UNITS PRECAUTIONS: READ THIS BEFORE OPERATING YOUR UNIT ■Do not operate this unit upside-down.It may overheat, possibly causing damage ■Never open the cabinet. If something drops into the set, contact your dealer To eliminate condensation: •CD pickup IMPORTANT WARNING NOTE CAUTION FOR CARRYING THIS UNIT CAUTION FOR MOVING THIS UNIT FEATURES General c5-SpeakerConfiguration Front L, R: 100W + 100W (6Ω ) RMS Output Power, 10% THD, 1 kHz (See figure 1 on page 3 at the beginning part of this manual.) 1Preset Equalizer Mode Indicator (MUSIC) 2Sound Field Program Indicator (PROGRAM) 3Karaoke Mode Indicator (KARAOKE) 4Center Channel Mode (NOR/PHANTOM) Indicator (See figure 3 on page 5 at the beginning part of this manual.) 1 Remote Control Transmitter Window I Track Number Input Buttons 2 Preset Station Number Buttons J TIME Button Speaker configuration Speaker placement Good No good Only for customers who use the YAMAHA NS-P30speaker system (separate purchase) “NS-P30” ■Mounting the rear speakers (NX-E70) To hang in a side long way WARNING: ■Mounting the center speaker (NX-C70) Connecting speakers (See figure 6 on page 6.) (See figure 7 on page 7.) (1) (2) 15 m (49 feet) (4) (3) Connecting external components (See figure 8 on page 8.) Turning this unit on or into the standby mode Volume control Listening with headphones Setting the clock Adjusting brightness of the display Adjusting input level of sources respectively (L and R) Press the VOLUME + (up) button to increase the volume Speaker balance adjustment Before operation NORMAL (For 5-speaker configuration): Page Press the OPEN/CLOSE button to open the disc table COMPACT DISC PLAYER OPERATION DISC selector buttons STANDBY/ON1 7, 1 CD playback Direct-selectionplayback A. For example, to choose selection Press the “5” button B. For example, to choose selection (1)Press the “+10” button To play back a desired track on the disc (Skip search) The beginning of any track can be found automatically 1 Select a disc and begin playback 2 Press the button to advance or button to reverse through the disc Press once for each track to be advanced or reversed Program play You can program up to 20 tracks in any desired order 1 Load discs and close the disc table 2 When in the stop mode, press the PROG button to prepare for programming “PROG” and To stop program play •Press the stop button. The first programmed track number will be displayed To resume playback, press the play/pause To cancel a programmed sequence There are several methods as described below Random play To cancel the random play (off) S REP F REP Repeat play Repeat play modes SINGLE REPEAT (S REP) FULL REPEAT (F REP) When the unit is in the all disc play mode: Switching the time display [Example] TUNING OPERATION Automatic tuning 3 Press the AUTO/MAN’L button so that “AUTO” lights up on the display (In this mode, stations are received in stereo or monaural automatically.) 4 Press the button to tune to a higher frequency, or Manual preset tuning To store stations (Example: To store a station to A1) 2 Press the tuner MEMORY button *“MEMORY” and “PRESET” will flash on the display for about 5 seconds Automatic preset tuning When the automatic preset tuning is completed; To listen to or watch a source on an external unit connected with this unit To record a source to tape USING GRAPHIC EQUALIZER PROGRAM 100 1K 10K Preset graphic equalizer modes (MUSIC) Mode Adjusting the graphic equalizer for your desired sound taste Turning the equalizer to “flat” (the state with no equalization applied) Storing your own equalizer patterns USING SOUND FIELD PROCESSOR Listening to the music with a sound field effect PRO LOGIC 3 STEREO HAL OFFARENA MONO MOVIE STADIUM DISCO Adjusting CENTER LEVEL Adjusting REAR LEVEL Adjusting DELAY TIME turning the MIC TONE control * Turning the MIC TONE control clockwise makes tonal quality softer To cancel the karaoke mode the next page.) KARAOKE OPERATION Singing karaoke 1 Connect one or two microphones to the MIC jack(s) on the front panel LR L R VOCAL CUT (off) For descriptions of the karaoke modes, see the list below Adjusting the level of echo effect Control range: On the front panel: On the remote control transmitter: To record: 2 Prepare to sing Karaoke by using microphone(s) 6 Begin singing Karaoke With this recording method, the effect of the HOW TO USE THE BUILT-INTIMER Timer play 1 Prepare the source to be played For tuner: Tune in to the station you will listen to ➂ ON TIME/time setting mode STANDBY/ON HOUR MIN DISPLAY TIME ADJ ➃OFF TIME/time setting mode To cancel the timer play setting Sleep timer operation This unit can be turned into the standby mode automatically 3 Press the SLEEP button repeatedly until the desired sleep OFF SLEEP ↑ *The SLEEP indicator will light up to indicate that the sleep timer is on TROUBLESHOOTING SYMPTOM CAUSE REMEDY CARE OF COMPACT DISCS mark this surface Keep your discs away from direct sunlight, heat and excessive moisture Always hold the CDs by the edges. Fingerprints, dirt or