Yamaha EMX120CD Listening with headphones, Setting the clock, ADJUSTMENTS, STARTING THE OPERATION OF THIS UNIT, Changes, Changes

STARTING THE OPERATION OF THIS UNIT

PHONES

CD CHANGER RECEIVER EMX–120CD								A/B/C/D/E	PRESET/TUNING/BAND
						OPEN/CLOSE	DISC
							CHANGE
						DISC 1	DISC 2	DISC 3
PROGRAM						INPUT SELECTOR		VOLUME
						CD	TUNER
STANDBY/ON
ECHO	MUSIC	ECHO
						VCR•LD/TV•CD•TAPE/MD•TUNER
KARAOKE		MEMORY
PHONES						MIC TONE		MIC	MIC MIXING
		DISPLAY	MEMORY AUTO/MAN’L	REPEAT	TIME	INPUT TRIM

Listening with headphones

•Be sure that your headphones have a 3.5 mm (1/8”) diameter plug and are between 16 ohms and 50 ohms impedance. Recommended impedance is 32 ohms.

•When headphones are connected, the speakers are defeated automatically and you can listen to the sound to be output from the front speakers through headphones. Adjust the VOLUME control for desired volume.

ADJUSTMENTS

Setting the clock

1

2

DISPLAY

1 While the power is on, press the DISPLAY button to display the time. If this unit is in the standby mode, you can proceed to the next step.

2 While holding the TIME ADJ button pressed, press the HOUR button and set the hour.

MEMORY REPEAT TIME

TIME ADJ HOUR MIN

Changes.

3

MEMORY REPEAT TIME

TIME ADJ HOUR MIN

Changes.

*Press the HOUR button once to advance the time by 1 hour. Press and hold to advance continuously.

3 While holding the TIME ADJ button pressed, press the MIN button and set the minute.

*Press the MIN button once to advance the time by 1 minute. Press and hold to advance continuously.

Australia model uses a 24-hour display. For General model, either the 24-hour display or the 12-hour display [shown by “AM (PM) 12:00”] is selected depending on the setting of the FREQUENCY STEP switch on the rear panel, so you cannot select a desired type freely.

In the event of a power failure or when the AC supply lead is disconnected.

The time display will go out, however, the clock will function for about 5 minutes without power supply. So you do not have to reset the time if the AC power supply is resumed within about 5 minutes.

When the AC power supply is resumed after more than 5 minutes pass without power supply, the time display will flash on and off to indicate that the time must be reset.

E-14