Yamaha EMX120CD Manual preset tuning, To store stations, or button repeatedly, For easier operation, To recall a preset station, (In this case, select “1”.)

Tune in to a desired station.

(Refer to the previous page for tuning procedure.)

TUNING OPERATION

3, 1

CD CHANGER RECEIVER EMX–120CD								A/B/C/D/E	PRESET/TUNING/BAND
						OPEN/CLOSE	DISC
							CHANGE
						DISC 1	DISC 2	DISC 3
PROGRAM						INPUT SELECTOR		VOLUME
						CD	TUNER
STANDBY/ON
ECHO	MUSIC	ECHO
						VCR•LD/TV•CD•TAPE/MD•TUNER
KARAOKE		MEMORY
PHONES						MIC TONE		MIC	MIC MIXING
		DISPLAY	MEMORY AUTO/MAN’L	REPEAT	TIME	INPUT TRIM

2, 5 4, 2

		CD	TUNER
4, 2	1	2	3	4	5
	6	7	8	PRESET
	1	2	3	4	5
	6	7	8	9	0	3, 1
	A	B	C	D	E
	TIME	PROG			+I0
	MODE		REPEAT	RANDOM	OPEN/CLOSE
	DISC SKIP			STOP	PLAY/PAUSE
	CD	TUNER		INPUT
	CENTER/REAR	TEST	FLAT
	/DELAY
	ECHO LEVEL		KARAOKE	MUSIC	PROGRAM
	SLEEP	STANDBY/ON			DISPLAY

VOLUME

Manual preset tuning English

This unit can store station frequencies selected by tuning operation. With this function, you can select any desired station only by calling the corresponding preset station number. Up to 40 stations (8 stations x 5 groups) can be stored.

To store stations(Example: To store a station to A1)

1

2 Press the tuner MEMORY button.*“MEMORY” and “PRESET” will flash on the display for about 5 seconds.

3 Select a desired group (A – E) of preset stations by pressing the A/B/C/D/E button confirming it on the display, before “MEMORY” goes out.

(In this case, select group A.)

4 Select a preset station number by pressing the or button repeatedly before “MEMORY” goes out.

(In this case, select “1”.)5 Within about 5 seconds, press the tuner MEMORY button again.

AUTO

MHz

The currently displayed station has been programmed to A1.*In the same way, program other stations to A2, A3 ... A8.

*You can program more stations to the preset station numbers of other groups in the same way by selecting other groups in step 3.

To recall a preset station1 Select a group of preset stations by pressing the A/B/C/D/E button.2 Select the desired preset station number by pressing theor button repeatedly.

Notes

•A new setting can be programmed in place of the former one.

•For presets the setting of the AUTO/MAN’L button is stored along with the station frequency.

For easier operation

By using the preset station number buttons and the A,B,C,D,E selector buttons on the remote control transmitter, a preset station number and a group can be selected directly.

E-27