18 Front and rear panel
EMX5000-20/EMX5000-12—Owner’s Manual
FFOOT SW (EFFECT 2) TAP jack
When TAP DELAY is selected as the internal
effect type for the EFFECT 2 RTN channel, you
can connect a separately sold FC5 foot switch to
this jack, and press the foot switch to set the delay
time to the corresponding interval. When you
press the foot switch several times, the delay time
will be set to the interval between the last two
presses.
GLAMP jack
This is an XLR (3-pin female) output jack that
supplies power to a lamp.
Rear panel
1AC inlet
Connect the socket end of the included AC cable
to this inlet. Connect the plug end of the cable to
an AC outlet of the voltage printed below the
inlet.
2POWER switch
This switch turns on/off the power to the
EMX5000-20/EMX5000-12.
3SPEAKERS (speaker output) jacks
These jacks are used to connect speakers.
Jacks 1 are Speakon-type connectors. Jacks 2 are
1/4" phone jacks. The setting of the control panel
power amp select switch Y will determine the
signal that is output to these jacks, and the num-
ber and appropriate impedance of the speakers
that can be connected.

21

3

Note: Before you turn the power of the
EMX5000-20/EMX5000-12 on or off, the fad-
ers and controls in the master section of the
control panel must be lowered to the minimum
position.