12 Front and rear panel
EMX5000-20/EMX5000-12—Owner’s Manual
GPFL (pre-fader listen) switch
When this switch is turned on, the signal at the
point before the ST control knob F is sent to the
PHONES jack (input/output panel D).
■Master control section
In this section, you can adjust the final level of
the outputs.
HAUX 1 fader
The AUX 1 fader adjusts the final level of the sig-
nal sent from the AUX 1 bus to the AUX SEND 1
jack (input/output panel 8). If the Power amp
select switch Y is set to AUX 1-MONO, using
this fader enables you to adjust the level of the
signal sent from the SPEAKERS A 1/2 jacks to the
speakers.
IAUX 2 fader
The AUX 2 fader adjusts the final level of the sig-
nal output from the AUX 2 bus to the AUX
SEND 2 jack (input/output panel 8). If the
Power amp select switch Y is set to AUX 1-
AUX 2, using this fader enables you to adjust the
level of the signal sent from the SPEAKERS B 1/2
jacks to the speakers.
JMONO OUT fader
The MONO OUT fader adjusts the final level of
the monaural signal output from the STEREO
bus to the MONO OUT jack (input/output panel
C).
If the Power amp select switch Y is set to AUX 1-
MONO, this fader also adjusts the level of the sig-
nal sent from the SPEAKERS B 1/2 jacks to the
speakers.
If the Power amp select switch Y is set to MONO
BRIDGE, this fader adjusts the level of the signal
sent from the SPEAKERS A 1 jacks to the speaker.
KST OUT fader
The ST OUT fader adjusts the final level of the
signal sent from the STEREO bus to the ST OUT
jacks (input/output panel 0). If the Power amp
select switch Y is set to ST L-R, this fader also
adjusts the level of the signal sent to the SPEAK-
ERS jacks (rear panel 3).
LAFL (after fader listen) switch
When this switch is on, the output signal that
passes through the corresponding fader is sent to
the PHONES jack (input/output panel D). Use
these switches when you wish to monitor a par-
ticular output signal through the headphones.
■2TR IN section
In this section, you can adjust the input level of a
cassette deck or a CD player that is connected to
the 2TR IN jacks (input/output panel 5).
MST (stereo) control
This knob adjusts the level of the signal sent from
the 2TR IN jacks to the STEREO bus.
NPFL (pre-fader listen) switch
When this switch is on, the signal input from the
2TR IN jacks is routed at the point before the ST
control M to the PHONES jack (input/output
panel D).
Note: The ST control setting does not affect
the level of the signal sent to the PFL/AFL buses
(pre-fader send).

H I J K

LNote: The setting of this fader does not affect
the signal output from the STEREO bus to the
ST SUB OUT jacks.

N

M