Yamaha EMX5000-12, EMX5000-20 POWER indicator, YAMAHA SPEAKER PROCESSING, STAND-BY, Other indicators and controls

Control panel 15

EMX5000-20/EMX5000-12—Owner’s Manual

■POWER indicator

[POWER indicator

This indicator will light up when the power of the

EMX5000-20/EMX5000-12 is turned on.

■YAMAHA SPEAKER PROCESSING

\ON/OFF switch

This switch enables you to compensate the low

range of the speakers. The low range balance

when this switch is on varies depending on the

speakers.

First, check the low range balance by auditioning

the resultant sound, then set this switch to on or

off.

■STAND-BY

]ON/OFF switch

This switch mutes (silences) the input signals

from channels 1–16 (EMX5000-20) or channels

1–8 (EMX5000-12). The indicator will blink

when this switch is on.

■Other indicators and controls

^Peak level indicator

This indicator allows you to monitor the level of

the signal output from the ST OUT jacks. The “0”

indicator lights up when the output level reaches

+4 dB.

aPHONES control

This knob adjusts the level of the signal moni-

tored via the PHONES jack (input/output panel

D).

bST SUB OUT control

This knob adjusts the ﬁnal level of the signal sent

from the STEREO bus to the ST SUB OUT jacks

(input/output panel A).

cLPF control, ON/OFF switch

This switch applies a low-pass ﬁlter to the signal

that is output from the PFL/AFL bus to the

MONO OUT jack. The frequency is indicated by

the position of the slit in the control trimmer that

is set into the panel above the switch. To adjust

the frequency, use a slotted screwdriver to turn

the control to the desired position. This will out-

put the region below the frequency (80–120 Hz)

you specify by the control knob.

Use this when you are using a sub-woofer.

[

]

Note: The setting of this control does not affect

signals that are sent from the STEREO bus to

the ST SUB OUT jacks and the SPEAKERS

jacks.