20 Installation/Connections
EMX5000-20/EMX5000-12—Owner’s Manual
• Two channel parallel connections
If you connect two speakers in parallel to the SPEAKERS A and SPEAKERS B jacks, use speakers with an
impedance in the range of 8–16 ohms. A maximum output of 500W + 500W will be obtained when 8-ohm
speakers are used.
■When the power amp select switch is set to MONO BRIDGE:
•Bridge connection
Connect only one 8–16 ohm speaker to the A1 jack. The speaker will output the combined monaural signal of
the STEREO bus. A maximum output of 1000 W will be obtained when an 8-ohm speaker is used.
If you are inputting a signal from the P.AMP IN jack, input it to P.AMP IN jack A.
Caution:
When using a bridge connection, do not connect a speaker to the B or A 2 jack.
Two-channel connection
Two-channel parallel connection
Main
Speaker Main/Monitor
Speaker Main
Speaker Main/Monitor
Speaker
or
or
* Use either the 1 (Speakon) jacks
or 2 (phone) jacks of and . * Use either the 1 (Speakon) jacks
or 2 (phone) jacks of and .
4Ω–8Ω4Ω–8Ω8Ω–16Ω8Ω–16Ω8Ω–16Ω8Ω–16Ω
Main Speaker
Bridge connection
No
connection
* Use the 1+(+) and 2+(–) pins of the 1
jack.
8Ω–16Ω
No
connection