Maintenance

(2) Remove the four screws, and then re-

(8) While holding the steering pole, move the

move the handlebar cover.

lock pin to the stowed position, and then

 

lower the steering pole.

1

1Handlebar cover

(3)Turn the handlebars so that the left han- dlebar grip is facing down.

(4)Loosen the locknut.

(5)Tighten or loosen the adjusting nut until the desired amount of friction is obtained.

EJU31288

Adjusting the jet thrust nozzle angle

The angle of the jet thrust nozzle can be adjusted to two settings to suit operator prefer- ence.

To adjust the jet thrust nozzle angle:

(1)Remove the two bolts, and then remove the steering pole cover.

1Adjusting nut

2Locknut

(6)While holding the adjusting nut with a wrench, tighten the locknut to the speci- fied torque.

Tightening torque:

Locknut:

29.0Nm (2.96 kgf-m, 21.4 ft-lb)

(7)Securely install the handlebar cover and four screws in their original positions.

1Steering pole cover

(2)Pull back the outer sleeve of the steering cable joint, and then disconnect the joint from the steering cable pivot bolt.

1Steering cable joint

61