AG-Stomp
TEST PROGRAM
A. CONNECTION OF TERMINALS
• INPUT | Monaural input |
• OUT L/MONO | Balance output (RL 47KΩ) |
• OUT R | Balance output (RL 47KΩ) |
• HEAD PHONES | Stereo output (RL 33Ω) |
• EXP. PEDAL | FC7 or Connect VR of B50K. |
JK pin 1: MIN of VR | JK pin 2: MAX of VR |
JK pin 3: CENTER of VR | |
• DIGITAL OUT | Connect the DA converter. |
• MIDI IN, MIDI OUT | Connect IN and OUT with the |
| DIN 5P cable. |
• POWER SUPPLY | OFF |
• AC IN | Connect the AC adaptor |
B. CONTENTS OF THE TEST PROGRAM
0: LED Check
1: SW Check
2: VR Check
3: MIDI Check
4: SRAM Check
5: FLASH ROM Check
6: DSP Check
C. STARTING THE TEST PROGRAM AND CHECKING
While pressing the MANUAL, STORE and ROOM switches, turn on the POWER switch. The TEST program will then be started. At this time, check to make sure that the model name “AG.S” is displayed for about 2 seconds. The digit at the left end of the
D. SELECTING THE TEST NUMBER
• Using the UP and DOWN switches, select the test number and press the STORE switch to start testing.
E. OPERATION OF THE TEST PROGRAM AND CHECKING 0: LED check
(1) Using the UP and DOWN switches, select “0”. (This step can be skipped if “0” is already selected.)
(2) Press the STORE switch.
• LED segments light up one after another starting with “UP”. When “MIC” is reached, “BANK”, “1”, “2” and “3” light up followed by 7 segments in the following order from the left end. After that, all LED segments light up and go out.(Fig.1)
1 
2 
3
1
6 7 2
5 3
4 8
Fig.1
28
