SETTING THE CLOCK

(See figure D on page 12.)

1 While the power is on, press the DISPLAY button to display the time. If the power is off, you can proceed to the next step.

2 While holding the TIME ADJ button pressed, press the HOUR button and set the hour.

*Press the HOUR button once to advance the time by 1 hour. Press and hold to advance continuously.

*To reverse the hour, press the button instead of the HOUR button.

3 While holding the TIME ADJ button pressed, press the MIN button and set the minute.

*Press the MIN button once to advance the time by 1 minute. Press and hold to advance continuously.

*The hour setting will not advance even if minute is advanced from “59” to “00”.

*To reverse the minute, press the button instead of the MIN button.

Europe, U.K., Australia, China and Singapore models use a 24-hour display. U.S.A. and Canada models use a 12-hour display shown by “AM (PM) 12:00”. For General model, either the 24-hour display or the 12-hour display is selected depending on the setting of the FREQUENCY STEP switch on the rear panel, so you cannot select a desired type freely.

In the event of a power failure or when the AC supply lead is disconnected.

The time display will go out, however, the clock will function for about 5 minutes without power supply. So you do not have to reset the time if the AC power supply is resumed within about 5 minutes.

When the AC power supply is resumed after more than 5 minutes pass without power supply, the time display will flash on and off to indicate that the time must be reset.

ADJUSTING BRIGHTNESS OF THE DISPLAY

If desired, you can adjust brightness of the display.

1 Press and hold the DISPLAY button for more than 2 seconds so that “DIMMER±0” appears on the display.

2 Holding the DISPLAY button pressed, turn the VOLUME control clockwise to increase or counterclockwise to decrease brightness.

This adjustment can be made even though the power of this unit is off (in the standby mode).

Control range

When the power is on: ±0 to –6 (Preset value: ±0)

When the power is off: +3 to –3 (Preset value: ±0)

VOLUME CONTROL

VOLUME

VOLUME

DOWN

UP

Front panel operation

Rotate the VOLUME control to the “UP” direction to increase the volume, and to the “DOWN” direction to decrease the volume.

Remote control operation

Press the VOLUME + button to increase the volume and the VOLUME – button to decrease the volume.

*Adjusted volume level is shown by the volume level meter and in figures on the display.

VOLUME

E-14