Recording adjustments and other operations are performed from the tape deck, MD recorder or VCR. Refer to the
y
If a tape deck or MD recorder is being used for recording, you can
instructions for these components.
– | + | – | + |
2 1,4
monitor the sounds being recorded by pressing TAPE/MD MON / EXT. DECODER (or TAPE/MD).
Notes
• The DSP program and the setting of VOLUME, BASS, TREBLE |
and BALANCE have no effect on the material being recorded. |
• Composite video and S video signals pass independently through |
this unit’s video circuits. Therefore, when recording or dubbing |
video signals, if your video source component is connected to |
provide only an S video (or only a composite video) signal, you |
can record only an S video (or only a composite video) signal by |
your VCR. |
• A source connected to this unit only through the digital terminals |
cannot be recorded by the tape deck, MD recorder or VCR |
4
2 
1 Set VOLUME to the “ m” position.
connected to this unit. |
• A source connected to the EXTERNAL DECODER INPUT |
terminals of this unit cannot be recorded. |
• Check the copyright laws in your country to record from records, |
CDs, radio, etc. Recording of copyrighted material may infringe |
copyright laws. |
If you play back a video source that uses scrambled or encoded signals to prevent it from being dubbed, the picture itself may be disturbed due to those signals.
Front panel
2Select the source you want to record.
or
Front panel | Remote control |
3Begin recording by the tape deck, MD recorder or VCR connected to this unit.
4Play the source and then turn up the volume to confirm the input source.
or
Front panel | Remote control |
32