Yamaha HTR-5240 DIGITAL SOUND FIELD PROCESSOR (DSP) EFFECT, Selecting a DSP Program, off the effect speakers), Canceling the Sound Effect (turning, ■On the front panel

DIGITAL SOUND FIELD PROCESSOR (DSP) EFFECT

Selecting a DSP Program

You can enhance your listening experience by selecting a DSP program. Refer to pages 25 to 27 for details about each program.

– + – +

2

2

3

■On the front panel

1Make sure that the effect speakers (center, rear, and subwoofer) are turned on.

2Press PROGRAM h or l

repeatedly to select the desired program.

The name of the selected program appears on the display.

DSP program name

■On the remote control

1Make sure that the effect speakers (center, rear, and subwoofer) are turned on.

2Press AMP(TUNER) on the

component selector.

3Press PRG+ or PRG–

repeatedly to select the desired program.

The name of the selected program appears on the display.

DSP program name

y

If desired, adjust the delay time and the sound output level of each speaker. (Refer to pages 37 and 38 for details.)

Notes

•You can select a DSP program for each of the input sources. Once you select a program, it is linked with the input source selected at that time. So, when you select the input source next time, the same program is automatically selected.

•When a monaural source is being played with PRO LOGIC/ Normal or PRO LOGIC/ENHANCED, no sound will be heard from the main speakers and the rear speakers. Sound can only be heard from the center speaker. However, if “CENTER SP” in the SET MENU is set to the NONE position, the center channel sound is output from the main speakers.

•When a source connected to the EXTERNAL DECODER INPUT terminals of this unit is selected, the digital sound field processor cannot be used.

Canceling the Sound Effect (turning

off the effect speakers)

Press EFFECT to cancel the sound effect and

monitor only the main	Front panel
	or
sound.
Press EFFECT again to turn the
sound effect back on.
	Remote control

Notes

•If the sound effect is canceled when Dolby Digital or DTS is decoding, the sounds of all channels are mixed and output from the main speakers.

•If you turn off the sound effect when Dolby Digital or DTS is decoding, it may happen that the sound is output faintly or not output normally, depending on the source. In that case, turn back on the sound effect.

24