TROUBLESHOOTING
■Remote controlProblem | Cause | Remedy | Refer to | |
|
|
| page | |
|
|
|
| |
The remote control | Wrong distance or angle. | The remote control will function within a | 7 | |
does not work nor |
| maximum range of 6 m (20 feet) and no more |
| |
function properly. |
| than 30 degrees |
| |
|
|
|
| |
| Direct sunlight or lighting (from an | Reposition this unit. | — | |
| inverter type of fluorescent lamp, etc.) is |
|
| |
| striking the remote control sensor of this |
|
| |
| unit. |
|
| |
|
|
|
| |
| The batteries are weak. | Replace all batteries with new ones and press | 3 | |
|
| RESET. |
| |
|
|
|
| |
| The internal microcomputer has | Remove the batteries from the battery | 3 | |
| “frozen”. | compartment once and then put them back. |
| |
|
|
|
| |
The remote control | The batteries of this remote control and/ | Replace the batteries. | 3 | |
does not “learn” new | or the other remote control are too weak. |
|
| |
functions. |
|
|
| |
The distance between the two remote | Place the remote controls at the proper distance. | 44 | ||
| ||||
| controls is too much or too little. |
|
| |
|
|
|
| |
| The signal coding or modulation of the | Learning is not possible. | 44 | |
| other remote control is not compatible |
|
| |
| with this remote control. |
|
| |
|
|
|
| |
| Memory capacity is full. | Further learning is not possible without deleting | 45, 46 | |
|
| unnecessary functions. |
| |
|
|
|
| |
| The internal microcomputer has | Remove the batteries from the battery | 3 | |
| “frozen”. | compartment once and then put them back. |
| |
|
|
|
| |
Continuous functions | The learning process is incomplete. | Be sure to press and hold the function button on | 44 | |
such as volume |
| the other remote control until “OK” appears in |
| |
adjustment are learned, |
| the display window. |
| |
but operate only for a |
|
|
| |
moment before |
|
|
| |
stopping. |
|
|
| |
|
|
|
|
After this unit has been exposed to a strong external electric shock (such as lightning and strong static electricity) or if you mishandle the operation of this unit, it may not function properly. In these cases, set this unit in the standby mode, disconnect the power cord, plug it back in after 30 seconds, and start operating.
INFORMATION | ADDITIONAL |
|
|
English
75